Winegard Car Satellite TV System SKA 733 User Manual

Installing the Reflector, LNBF, & Feed Arm  
Note that the reflector, LNBF, and feed arm are packaged separately as SKA-733.  
1. Press and hold “POWER” for two seconds to turn on the interface box. Wait until the interface box finishes  
“connecting to antenna.” The TRAV’LER® antenna may enter the search routine after ten seconds. Pay attention to  
the pinch points as the antenna raises!  
2. Wait until the antenna has at least raised to a position in which the lift arms are perpendicular to the roof. Then, press  
“POWER” and “SELECT” at the same time. The antenna should stop moving.  
3. Unplug the interface box.  
4. Insert the two longer screws into the top two holes in the front of the reflector.  
5. Slide a wedge-shaped clamp onto each screw sticking out the back of the reflector.  
6. Thread a nut onto each screw; make sure the nut is tight to keep the clamp from falling.  
7. Align the two anchor posts on the back of  
the reflector with the two notches in the skew  
plate (see fig. 1). Then, set the reflector on the  
Notches in  
skew plate  
skew plate; the reflector should be positioned  
with the LNB arm at the bottom of the plate.  
Carefully use the clamps on the back of the  
reflector to hold the reflector in place (see  
fig. 2A); make sure that the thicker part of the  
clamp is to the outside of the reflector.  
Anchor posts  
in reflector  
FIGURE 1. Anchor posts and notches to align  
8. Once the top screws and clamps are in place, install the lower screws and clamps.  
9. With the bracket mounted securely, connect the four coax cables to the mount (see fig. 2B).  
10. Locate the cable tie on the coax cables that you just connected to the mount. Place the p-clamp on the cables so that  
it is just below this cable tie. If the cable tie is missing, install the clamp 14” from the end of the connectors.  
11. Carefully screw this clamp to the front of the lift arm using the provided 5/16” screw (see fig. 2C). Warning: Be careful  
not to strip out the hole for the 5/16” screw when you replace the clamp holding the coax cables to the arm. Do not  
use a power tool. Do not overtighten this screw.  
+
+
+
A
B
C
FIGURE 2. Installing reflector, LNBF, and feed arm. A, Reflector held on skew plate with clamps. B, Coax cables connected. C, P-clamp on lift arm.  
12. Plug in the interface box.  
13. Press and hold “POWER” for two seconds to turn on the interface box. Press the Power button again to stow the antenna.  
2452259  
 

Westinghouse Fan WJ WH05 User Manual
Westinghouse Marine Lighting W 031 User Manual
Westinghouse Slow Cooker WST3012ZE User Manual
Whirlpool Clothes Dryer 3XWED5705SW0 User Manual
Whirlpool Range W10258095A User Manual
Williams Sound Games 16P 3001 103 R T User Manual
Windsor Vacuum Cleaner 10052410 User Manual
Wolf Appliance Company Microwave Oven SO30F S User Manual
Xerox Printer XD125F User Manual
Zanussi Freezer ZCF 220 User Manual