JKP90SP
GE® 27" Built-In Double Microwave/Thermal Wall Oven
Dimensions and Installation Information (in inches)
10
KW Rating
Recommended
C
L
junction box
locations.
A
6.4
4.8
240V
208V
2 x 4 or
equivalent
runners
Locate junction
box either 5" MIN.
below cutout
floor or 48" MIN.
above cutout
floor
Allow 3/4" for overlap
of oven over all
edges of cutout
Breaker Size
C
30 Amps
30 Amps
240V
208V
D
Suitable
bracing
to support
runners
2" X 4" or
equiv. runners
18"
B
over centerline
of cabinet
H
Note: Cabinets installed adjacent to wall ovens
must have an adhesion spec of at least a 194°F
temperature rating.
(must support 275 lbs.)
Access
from
adjacent
cabinet
required
G
Note: if marks, blemishes or the cutout opening is
visible above the installed oven, it may be necessary
to add wood shims under the runners and front trim
until the marks or openings are covered.
Cabinet
27"
27" min.
23-5/8"
A – Cabinet width required
B – Minimum cabinet depth
C – Opening width
Minimum
cutout location
from floor
21
E
25" min. - 25-1/4" max
41-1/4" max
22"
Conduit
(48-1/2"
long)
D – Opening height
E – Minimum cutout location from floor
F
Oven
F – Overall depth*
G – Overall height with trim
Overall height without trim
H – Overall width
Note: Door handle protrudes 3" from door face.
Cabinets and drawers on adjacent 45° and 90° walls
should be placed to avoid interference with the handle.
23-5/8"
43" - 43-7/8"
42-1/8"
Allow minimum of
21" for clearance
to adjacent corners,
drawers, walls, etc.
26-5/8"
Electric wall ovens are not approved for installation
with a plug and receptacle. They must be hard wired
in accordance with installation instructions.
*Depth including door handle is approximately 26-7/10" min. to
26-8/10" max.
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
Note: These ovens are not approved for stackable or
side-by-side installations.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Listed by
Underwriters
Laboratories
Specification Created 5/09
320359
|