Waring Popcorn Poppers WPM40 User Manual

PROFESSIONAL  
POPCORN MAKER  
WPM40  
For your safety and continued enjoyment of this product,  
always read the instruction book carefully before using.  
 
14. Do not place the unit on or near a hot gas or electric  
burner or in a heated oven.  
15. Extreme caution must be paid when moving the  
appliance containing hot oil or other hot liquids.  
16. Turn ALL switches to OFF position before  
disconnecting power plug from the wall supply outlet.  
17. Not recommended for outdoor use.  
18. Do not use appliance for other than intended use.  
19. To avoid overheating, always add oil and then kernels  
before operating.  
20. Extreme caution must be used when unloading  
popcorn. Always place the unit over a countertop  
so that residual hot oil or water running out will not  
cause burns.  
21. KEEP OUT OF REACH OF CHILDREN.  
22. DO NOT CLEAN USING ANY ABRASIVE MATERIAL.  
23. NEVER FORCE ANY PARTS OR BRACKETS INTO  
POSITION.  
24. NO PARTS ARE INTENDED FOR THE DISHWASHER.  
SAVE THESE INSTRUCTIONS  
FOR HOUSEHOLD USE ONLY  
 
PARTS  
1. Housing  
2. Kettle, Attachment Pins  
3. Door  
4. Tray (removable)  
5. Door Panel (removable)  
6. Kettle Lid  
7. Light/Warmer  
8. Stirrer  
9. Measuring Spoons and Scoops  
 
ASSEMBLING PROCEDURE  
FIGURE 1  
FIGURE 2  
Hold the kettle on  
the supporter.  
Screw the lips, axle  
fixer and stirrer onto  
the gear box.  
FIGURE 4  
Use the retaining pin to fix  
kettle at the right position.  
FIGURE 3  
Insert the pin through the  
kettle and supporter.  
FIGURE 5  
Finally, insert the internal  
kettle plug into the socket  
on the inner top of  
the popcorn housing.  
 
POPPING INSTRUCTIONS  
1. Make sure the popcorn maker is unplugged before you  
do any of the following.  
2. Before using the unit, please check carefully if voltage  
(120V – 60 Hz ) is suitable to your home.  
3. Clean the internal surface of the kettle with warm sudsy  
water, rinse well and dry with a clean cloth. Wipe down  
inner and outer housing with damp cloth.  
4. Main unit has 2 function switches as follows:  
– Light/warmer combination  
– POP switch to turn heater and stirrer on  
5. Hook the kettle onto the hanger of the main unit.  
6. Plug the power cord into an electric outlet.  
7. Insert the internal plug into the socket (see figure 5,  
previous page).  
8. Turn the light switch to the On position and the POP  
switch to the On position. The stirrer will begin to rotate  
in the kettle. Let the stainless steel kettle preheat about  
1 to 2 minutes. Open lid and add oil (1 tablespoon of  
vegetable, corn, peanut, or safflower oil). Immediately  
add ½ cup of corn kernels and close lid to the kettle.  
Caution: Lid might be hot – it is recommended to  
use an oven mitt.  
9. Popcorn starts popping out through the lid after about  
2 minutes. Yields up to 12 cups per batch in less than  
2½ minutes.  
10. When unit is finished popping – you will no longer  
hear the corn popping – immediately turn POP switch  
to the Off position and rotate the roller bar of the kettle  
down to release any remaining popcorn in the popper.  
This will also stop the remaining popcorn from cooking  
any further and avoid possible burning.  
11. The light/warmer may be left in the On position.  
12. Keep POP switch Off if the unit is not continuously  
in use.  
 
13. Keep only the Light/Warmer switch on.  
14. Remove plug from power supply if the unit is not  
being used.  
15. Repeat steps 7 to 10 for continuous popping.  
CLEANING AND MAINTENANCE  
It is strongly recommended to clean the kettle frequently to  
avoid burning excess oil onto the bottom of the inner pot.  
After using the popcorn machine, use a wet cloth to  
clean the main unit, main body and glass. It is strongly  
recommended to wash and dry the tray after each use to  
avoid any bacteria buildup.  
LIGHT/WARMER  
The light/warmer bulb can be replaced with a 120V, 60W  
maximum bulb only.  
QUICK CLEANING PROCEDURE  
Turn the POP control to Off. Pour 5 to 8 ounces of water  
(NO detergent is necessary) into inner pot. Switch to On  
to boil the water and let the stirrer turn in order to remove  
excess oil stuck on the surface. Pour out the water into a  
deep bowl and discard after about 1 to 2 minutes of boiling.  
CAUTION: THE KETTLE IS HOT.  
Or, remove the kettle and clean it with a Scotch-Brite®  
scouring pad. Do not immerse kettle or electrical plug  
in water.  
 
Any other trademarks or service marks of third parties herein  
are the trademarks or service marks of their respective owners.  
©2008 Waring Products  
Division of Conair Corporation  
150 Milford Road  
East Windsor, NJ 08520  
Printed in China  
WPM40 IB  
08WR100  
IB-8367A  
 

Tascam CD Player CD 160MK User Manual
Toastmaster Rice Cooker TRC5 User Manual
Tote Vision Computer Monitor LCD 4700HD User Manual
Toyota Automobile SV21 User Manual
Transition Networks Switch CSEFE10XX 10X User Manual
TRENDnet Network Card TEW 428UB User Manual
Triarch Indoor Furnishings 60149 User Manual
Tricity Bendix Kitchen Entertainment Center CSIE500 User Manual
Ultra Start Automobile Electronics KE 6 User Manual
Uniden Stereo System UH076SX User Manual