ZV750SPSS
GE Monogram® 36" Stainless Steel Wall-Mounted Hood
Dimensions and Installation Information (in inches)
This vent hood may be installed onto a wall and vented
to the outdoors, or it can be installed for recirculating
operation. All necessary parts for recirculating operation
are supplied with the hood. No kits required.
A decorative duct cover is provided to cover the duct
from the top of the hood to a 7'11" to 9'2" ceiling for vent
mode (9'6" for recirculating mode).
*Height
to Ceiling
Accessories:
An optional stainless steel duct cover is available for 9'
to 10'3" for vent mode (10'8" for recirculating mode) ceiling
heights. Order ZX7510SPSS optional duct cover
at the same time as the vent hood and have on site
before installation.
8-1/4"
34-5/8"
Dimensions and Clearances:
The vent hood should be installed 24" min. and 30" max.
above the cooking surface. The cooking surface should be
at least 36" above the floor. Installation will be easier if the
vent hood is installed before the range or cooktop/countertop
is installed.
21-5/8"
This hood can be installed over a Monogram electric or gas
cooktop. It cannot be installed over a Monogram professional
rangetop or range.
Installation Information: Before installing, consult
installation instructions packed with product or available
on monogram.com for current dimensional data.
24" to 30"
Note: Installation height should be measured from the
cooking surface to the lower edge of the hood.
36" Min.
The vent hood must be installed 24" min. and 30" max. above
the cooking surface depending on the ceiling height.
For answers to your Monogram,® GE Profile™
or GE® appliance questions, visit our website
at geappliances.com or call GE Answer Center®
service, 800.626.2000.
Listed by
Underwriters
Laboratories
Specification Created 6/09
130681
|