SUBWOOFERS
CS-SW100
CS-SW120
CP-SW100
CP-SW120
SPEAKER PARAMETERS
CS-SW100
800
CS-SW120
CP-SW100
1000
CP-SW120
1300
Peak Power (Watts)
Rated Power (Watts)
Frequency Response
Impedance
1000
200
250
250
325
33Hz - 1.2kHz
4 Ohms
27Hz -1kHz
4 Ohms
88dB
30Hz -1.2kHz
4 Ohms
24Hz -1kHz
4 Ohms
89dB
Sensitivity
87dB
88dB
Cone Material
Pressed Paper
Pressed Paper
Pressed Paper
Pressed Paper
Voice Coil Type
Round Wound
Copper
Round Wound
Copper
Round Wound
Copper
Round Wound
Copper
Mounting Depth
120mm (4-23/32”) 136mm (5-11/32”) 142mm (5-19/32”) 154mm (6 1/16”)
Mounting Diameter
228mm
(9”)
277mm
(10 15/16”)
228mm
(9”)
277mm
(10 15/16”)
INSTALLATION GUIDELINES
Ensure the audio system is turned off before making any connections to the amplifier, speakers or source unit.
Failure to do so could result in permanent damage to the audio system.
When wiring the subwoofer ensure that the wire is protected from sharp objects and always use rubber
grommets when wiring through metal panels. Ensure all terminals and connections are protected from the
vehicle chassis and from each other as failure to do so could result in permanent damage to the audio system.
When connecting the amplifier and subwoofer ensure you connect the positive and negative output wire from
the amplifier to the corresponding subwoofer terminals.
1) Ensure there is adequate clearance and depth for the subwoofer to be mounted
2) Mark out & cut the correct diameter hole
3) Drill the holes for the mounting screws
4) Insert the subwoofer and affix with the appropriate screws
|