Fluke Modem 2635A RF900USB User Manual

®
2635A-RF900USB  
900 MHz RF USB Modem  
Instruction Sheet  
Introduction  
Contacting Fluke  
The 2635A-RF900USB 900 MHz RF USB Modem  
(referred to as “the Modem”) is a radio-frequency  
transceiver that, used together with the 2635A-RF900  
Serial RS-232 Modem, creates a wireless link  
between Fluke Hydra Series Data Loggers and a  
computer (PC) running Hydra application software.  
To locate an authorized service center, visit us on the  
using any of the following numbers:  
USA: 1-888-99-FLUKE (1-888-993-5853)  
Canada: 1-800-36-FLUKE (1-800-363-5853)  
Europe: +31 402-678-200  
Japan: +81-3-3434-0181  
Singapore: +65-738-5655  
Anywhere in the world: +1-425-446-5500  
Note  
The modem operates in the 900 MHz  
frequency range and is approved by the FCC  
for use in the United States. Operation in  
other countries may violate local regulations.  
When operating outside the United States,  
check with the appropriate governing agency  
in the host country prior to Modem operation.  
Shipping Contents  
The Modem comes with the following items:  
Instructions for use with the Hydra Series (this  
sheet)  
This instruction sheet assumes familiarity with the  
Hydra software and Hydra Series Data Logger  
operation. If unfamiliar with Hydra software or the  
Hydra Series hardware, refer to the software user’s  
documentation or the appropriate Hydra Series Users  
manual. The Modem is shown in Figure 1.  
Quick Start Guide  
CD-ROM with documentation and software  
½ wave Dipole Antenna  
USB (Universal Serial Bus) 6 ft. cable  
Requirements  
The Modem requires a PC with one free USB port  
and Windows XP, 2000, or 98 SE.  
Config  
Switch  
Reset  
Switch  
Antenna  
Installation  
USB Port  
Connector  
Each wireless system requires two modems – one  
base station connected to a PC, and one remote station  
connected to a Hydra Data Logger. This USB Modem  
is used as a base station connected to the PC; the  
remote station connected to the Hydra is a 2635A-  
RF900 Serial RS-232 Modem.  
Data Out  
Data In  
e
t
a
r R  
n
o
Power Indicators  
n
P
e
t
n
A
h
c
i t  
f i g  
w
n
S
o
C
h
c
t
i t  
e
s
w
e
S
R
O
n
Of  
f
D
a
D
ta  
a
P
O
ta  
ow  
In  
u
t
e
r
S
e
ria  
P
o
l
r
t
7
-1  
Power Adapter Jack  
8
O-O  
V
To ease system setup, the Modem’s factory default  
settings are correct for proper PC-to-Hydra operation  
without further adjustments. There are no setup  
differences between the base and remote stations.  
D
-O  
C
efef01.eps  
Figure 1. 2635A-RF900USB 900 MHz RF USB Modem  
PN 2558814 November 2005 ©2005 Fluke Corporation. All rights reserved. Printed in U.S.A.  
1
 

Echo Chainsaw CS 330T CS 360T User Manual
Eclipse Fujitsu Ten GPS Receiver AVN2210p User Manual
Electro Voice Microphone N D478 User Manual
Extron electronic Network Card SCS 300 User Manual
Fisher Price Model Vehicle 77982 User Manual
Ford Automobile 2010 F 150 User Manual
FUNAI Flat Panel Television CIWL3706 User Manual
Garland Oven C0836 324A User Manual
GE Clothes Dryer DBLR333EGWW User Manual
Geemarc Telephone BDP400 User Manual