PARTS
ASSEMBLY
Launcher
Roll Cage
Air Tank
Slot
Roll Cage
Spoiler
Rescue
Raft
Slot
Tabs
• Insert and "snap" the tabs on the
front of the roll cage into the slots
near the front of the dune buggy.
Dune Buggy
Part Not Shown: Label Sheet
3
ASSEMBLY
• Insert and "snap" the tabs on the
back of the roll cage into the slots
near the back of the dune buggy.
Slot
• “Snap” the spoiler to the back of the
dune buggy.
Spoiler
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
PRINTED IN CHINA
J4512pr-0920
2007 Mattel, Inc. All Right Reserved. and ™ designate U.S. trademarks of Mattel, Inc.
©
®
4
LABEL DECORATION
• Make sure the areas where the labels
5
will be applied are clean and dry.
Wipe this product with a clean, soft,
dry cloth to remove any dust or oils.
• For best results, do not attempt to
apply a label more than once.
• Apply the labels as shown in
the illustrations.
®
2
1
3
5
®
4
1
5
BATTERY
INSTALLATION
BATTERY SAFETY
INFORMATION
For best results, use only alkaline batteries.
1.5V x 3
"AAA" (LR03)
In exceptional circumstances, batteries
may leak fluids that can cause a
chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
TOP VIEW
• Locate the battery compartment door
on the spoiler.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from
the product before charging.
• Insert three, new "AAA" (LR03)
alkaline batteries.
• Replace the battery compartment door
and tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• When lights or sounds become faint
or stop, it's time for an adult to
change the batteries!
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
• If removeable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
6
TO THE RESCUE
• Fit the launcher into the hole in either
the spoiler or the rescue raft.
Press to Launch
Air Tank
• Insert the air tank into the slot in the
launcher. Press the button to launch
the air tank.
Air Tank
• Place the runners on the sides of the
rescue raft onto the track under the
dune buggy. Push the raft under the
dune buggy until it “snaps” in place.
Rescue Raft
Track
Runner
Use only projectiles supplied with this toy.
Do not launch at people or animals or at
point blank range.
• Press the button on the dune buggy to
launch the rescue raft.
• Press the spoiler button for lights and
siren sounds.
Press for Lights
and Sounds
Press to Launch Raft
Rescue Raft
7
CARE
FCC Statement
• Wipe the toy with a clean cloth
dampened with a mild soap and
water solution.
United States Only
This equipment has been tested and found
to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Do not immerse the toy.
• Reorient or relocate the
receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user's authority to operate the equipment.
8
|