V7505
Actual product may appear different
than the product shown.
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” batteries (included).
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).
Assembly
B
Long
Handlebar
Short
Handlebar
A
Seat
3
4
• Turn the assembly upright.
• Fit the seat onto the assembly.
• Insert two screws into the holes on each side of the seat
and tighten.
• First, insert the long handlebar
through the hole in the pony head
Hint: You may need to turn the long handlebar to fit it into
the hole.
A
.
• Then, insert the short handlebar through the hole on the
B
other side of the pony head
.
• While holding the handlebars in place, carefully tip the pony
so that the short handlebar faces up.
• Insert a screw into the hole in the short handlebar
and tighten.
3
Battery Replacement
Battery Safety Information
1,5V x 3
“AA” (LR6)
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your toy. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the toy. Dispose of
batteries safely. Do not dispose of this product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only
to be charged under adult supervision.
For best performance, we recommend that you replace the
batteries that came with this toy with three, new “AA” (LR6)
alkaline batteries.
• Locate the battery compartment side of the pony.
• Loosen the screws in the battery compartment door with
a Phillips screwdriver. Remove the battery compartment door.
• Insert three “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the screws.
• If toy begins to operate erratically, you may need to reset the
electronics. Slide the power/volume switch on the toy off and
then back on.
• When sounds become faint or stop, it’s time for an adult to
change the batteries!
• Protect the environment by not disposing of this
product with household waste (2002/96/EC). Check
your local authority for recycling advice and facilities
(Europe only).
4
Roll-Along with Music
Power/Volume
Switch
Press the
button on the
pony's head for
musical tunes.
• Slide the power/volume
switch on the toy to on
with low volume
with high volume
; on
or off
.
5
Consumer Information
FCC Statement (United States Only)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
CONSUMER ASSISTA
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
Care
• Wipe with a clean cloth dampened with a mild soap and
water solution. Do not immerse.
ICES-003
• This Class B digital apparatus complies with Canadian
ICES-003 . Operation is subject to the following
two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
NMB-003
• C et appareil numérique de la classe B est conforme à la
norm e NMB-003 du Canada. L’utilisation de ce dispositif est
autorisée seulement aux conditions suivantes: (1) il ne doit
pas produire de brouillage et (2) l’utilisateur du dispositif doit
être prê t à accepter tout brouillage radioélectrique reçu,
meme si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
V7505pr-0920
PRINTED IN CHINA
©2010 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
|