G9158, J6113
Instructions
Enchanted
Motion
Musical
™
Gym
Overhead Play
Please keep this instruction sheet
for future reference, as it contains
important information.
1
Requires four “C” (LR14) alkaline
batteries (not included).
Adult assembly is required.
Tool required for battery installation:
Phillips screwdriver (not included).
Tummy-Time Play
2
Battery Installation
Battery Safety Information
In exceptional circumstances, batteries may leak fluids
that can cause a chemical burn injury or ruin your
product. To avoid battery leakage:
1.5V x 4
"C" (LR14)
•Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
Shown Actual Size
•Insert batteries as indicated inside the bat-
tery compartment.
•Remove batteries during long periods of non-use.
Always remove exhausted batteries from the product.
Dispose of batteries safely. Do not dispose of this
product in a fire. The batteries inside may explode
or leak.
•Never short-circuit the battery terminals.
•Use only batteries of the same or equivalent type,
as recommended.
•Do not charge non-rechargeable batteries.
•Remove rechargeable batteries from the product
before charging.
Battery Compartment Door
•If removable, rechargeable batteries are used,
they are only to be charged under adult supervision.
•Locate the battery compartment on the arch assembly.
•Loosen the screws in the battery compartment
door with a Phillips screwdriver. Remove the battery
compartment door.
•Insert four “C” (LR14) alkaline batteries.
Hint: We recommend using alkaline batteries for
longer life.
•Replace the battery compartment door and tighten the
screws with a Phillips screwdriver. Do not over-tighten.
•When lights, sounds or motions from this toy
become faint or stop, it’s time for an adult to
change the batteries!
Assembly
1
3
Post
Arch Assembly
• Grasp one of the soft tubes on the arch assembly
and turn the tube, as shown to unfold the toy.
• “Snap” the bird onto the post under the birdhouse,
as shown.
• Pull down on the bird to be sure it is secure.
2
Button
4
Tabs
Loop
• Place the play mat, print side up, under the
arch assembly.
• Fit the “buttons” on the end of each of the four tubes
through the slots in the corners of the play mat.
• Attach the toys to any of the tabs on the arch
assembly or to any loop on the play mat.
©2005 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.
PRINTED IN CHINA
G9158b-0920
Fluttering Motion, Music and Lights
Power/
Volume
Start
Switch
Button
Power/Volume Switch
Start Button
• Locate the power/volume switch on the side of the
birdhouse. Slide the switch to: on with low volume
• Locate the start button on the front of the birdhouse.
Press the start button for extended music, motion and
fun sounds.
or on with high volume
.
• Slide the power/volume switch to the off position
when not in use.
• Music plays continuously for about 10 minutes with
on and off motion.
• To restart, press the start button again, or baby
can bat the toys to activate music, motion and
sound effects.
Consumer Information
Storage
®
Call Fisher-Price Consumer Relations, toll-free at
1-800-432-5437, 8 AM - 6 PM EST Monday through
Friday. Hearing-impaired consumers using TTY/TDD
equipment, please call 1-800-382-7470.
®
Write to us at: Fisher-Price Consumer Relations,
636 Girard Avenue, East Aurora, New York 14052.
FCC Statement
(United States Only)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Remove the hanging toys from the arch assembly.
• Remove the play mat from the arch assembly.
• Grasp one of the soft tubes on the arch assembly
and turn the tube, as shown to fold up the toy.
• Place the arch assembly, play mat and hanging
toys in the storage bag provided.
Care
Play Mat
• Remove the play mat from the arch assembly.
• Wash the play mat in cold water on a gentle cycle.
Do not use bleach. Line dry the play mat.
Hanging Toys and Arch Assembly
• Wipe the surface with a clean cloth dampened
with a mild soap and water solution.
• Consult the dealer or an experienced radio/TV
technician for help.
Note: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
• Do not immerse the arch assembly.
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2. www.service.mattel.com
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303; www.service.mattel.com/uk.
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
|