864TRV Rectangular Face
Black 95800623
Nickel 95800624
Compatibility:
• 864TRV Fireplace
• 864ST Fireplace
• 864HO Fireplace
Packing List:
• Face
• (12) 8-32 Nuts
• (2) 10-24 1-1/2" Screws
• Face Mounting Brackets (upper and lower sets)
• (2) Face Brackets (w screws)
Installation Details
40-7/8”
SIDE OF FIREPLACE
35-5/8”
1”
5/16” TO 1”
NOTE:
This face has an adjustable bracket that allows for
different facing depths to be tucked under the face.
Special Instructions for 864HO Fireplaces
This face requires the outer grill deflectors to be removed. See the instructions below.
Remove the outer deflector on both sides
(use needle-nose pliers if necessary).
These tabs bend down
to allow for removal.
Re-attach the deflectors to the top louver
for future use if using a different face or
grill. Bend the tabs as shown, making
sure the deflectors are secure and flat.
Page 1 of 4
17601486 - 8/30/10
© Travis Industries, Inc.
864TRV Rectangular Face
Black 95800623
Nickel 95800624
2
The facing and hearth (if applicable) must be installed prior to attaching the face. See the installation manual
for complete details.
Raised
Fireplaces
Note how the tile is 1”
(maximum) above the
base of the fireplace.
Floor-Level
Fireplaces
Maximum 1`” Hearth
Page 3 of 4
17601486 - 8/30/10
© Travis Industries, Inc.
864TRV Rectangular Face
Black 95800623
Nickel 95800624
3
Install the face following the directions below.
Attach the upper brackets
to the face with the
a
included nuts.
The face is secured to the fireplace
with four screws. Two of the screws
are fastened to the upper brackets
with press nuts. The lower screws
are included with the face.
Slide the face into place. The
tabs on the upper brackets insert
b
into the slots on the fireplace
brackets, holding the face in place
while the screws are tightened.
Plated Surfaces
Use denatured alcohol and a soft cloth to clean plated surfaces. Marks
left on the surface may damage the face.
Denatured
Alcohol
Soft Cloth
Page 4 of 4
17601486 - 8/30/10
© Travis Industries, Inc.
|