DTP HDMI 330 • Setup Guide
This guide provides quick start instructions for an experienced installer to set up and operate the
Extron DTP HDMI 330 digital video extender. The DTP HDMI 330 transmitter and receiver pair can
extend an HDCP-compliant HDMI signal up to 330 feet (100 m).
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the Tx and Rx units as required.
DTP HDMI 330 Tx Rear Panel
DTP HDMI 330 Rx Rear Panel
SIG
LINK
SIG
LINK
INPUTS
POWER
12V
OVER DTP
OUTPUTS
POWER
12V
0.7A MAX
AUDIO
AUDIO
RS-232
IR
L
R
0.7A MAX
Tx Rx
G
Tx Rx
DTP OUT
DTP IN
7
2
1
4
3
7
4
5
6
Front Panel
INPUTS
Step 2 — Connections
AUDIO
OVER DTP
RS-232
IR
HDMI Input connector (Tx) — Connect an HDMI
cable between this port and the HDMI output port of
the digital video source.
a
Tx Rx
G
Tx Rx
DTP HDMI 330 Rx
NOTE: See “LockIt™ Lacing Brackets“on the back of this guide for to securely
3
fasten the input HDMI connector to the transmitter.
Audio input (Tx) — Connect an unbalanced stereo audio source to this 3.5 mm mini
stereo jack for an analog audio input.
b
c
Connected RS-232
and IR Device Pins
Tx/Rx
Pins
RS-232 and IR connectors — To pass serial or infrared data or control signals, such as
serial control of a projector, connect the master device to the transmitter and the slave
device to the receiver via the RS-232 and IR captive screw connectors on both units.
Transmit pin on connected unit
Receive pin on connected unit
Ground
Transmit pin on connected unit
Receive pin on connected unit
DTP RJ-45 connectors — Connect transmitter DTP Out to receiver DTP In.
Extron recommends that you terminate both cable ends in accordance with the
following specifications, at a minimum:
d
Pins:
12345678
TIA/EIA T
568 B
z
z
TIA/EIA T 568 B
z
CAT 6A, shielded
Pin Wire color
24 AWG, solid conductor
1
2
3
4
5
6
7
8
White-orange
Orange
ATTENTION: Do not connect these devices to a computer data
White-green
Blue
or telecommunications network.
White-blue
Green
Signal LED — Lights when the unit is receiving a clock signal on the HDMI input (for the transmitter)
or any valid signal on the DTP In connector (for the receiver).
White-brown
Brown
Link LED — Lights when a valid link is established between the units on the DTP cable.
TP Wires
HDMI Output connector (Rx) — Connect a display with an HDMI input for display of the
transmitted direct digital image.
e
f
OUTPUTS
AUDIO
R
L
to securely fasten the output HDMI connector to the receiver.
Audio Output connector (Rx) — Connect a balanced or unbalanced stereo or mono audio
device to the receiver via the Audio captive screw connector. See the drawing below.
No Ground Here
Tip
Ring
Sleeves
Tip
Tip
Sleeves
Tip
Ring
Do not tin the wires!
No Ground Here
Unbalanced Stereo Output
Balanced Stereo Output
ATTENTION: Connect the sleeves to the ground contact. DO NOT connect the sleeves to the negative (-) contacts.
|