Installation Guide
CVC 200
Component Video and HDTV to RGB Converter
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
800.633.9876 714.491.1500
FAX 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort, The Netherlands
+800.3987.6673 +31.33.453.4040
FAX +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Rd. #04-01
PM Industrial Bldg., Singapore 368363
+800.7339.8766 +65.6383.4400
FAX +65.6383.4664
Extron Electronics, Japan
Kyodo Building, 16 Ichibancho
Chiyoda-ku, Tokyo 102-0082
Japan
68-437-01 Rev. D
08 07
+81.3.3511.7655 FAX +81.3.3511.7656
© 2007 Extron Electronics. All rights reserved.
Cable Connection and Rate Selection (Cont’d)
Cable Connection and Rate Selection
Cable Connection and Rate Selection
Format rotary switch — Use an Extron Tweeker or other small
c
See figure 3 to identify the rear panel connections and Format rotary
switch
screwdriver to set the Format rotary switch to match the video
input format. The table below shows the switch settings and their
assigned input video formats.
1
2
4
100-240V
50-60Hz
Input
LISTED
1T23
I.T.E.
Position format(s) Standard or rate
INPUT
FORMAT
OUTPUT
C
0
1
2
3
4
5
6
Not used
Y, Pb, Pr
Y, Pb, Pr
Y, Pb, Pr
Not used
RGsB
NTSC/PAL
Y/G
P
B/B
PR/R
R
G
B
S
H
V
.35A
HDTV (480p, 576p, 720p, 1035i, 1080i)
Betacam
3
Format
switch
NTSC/PAL
Figure 3 — CVC 200 rear panel features
RGsB
Computer rates
NTSC/PAL
HDTV (720p)
HDTV (1080i)
HDTV (1080p)
7
8
9
A
B-F
Y, Pb, Pr
Y, Pb, Pr
Y, Pb, Pr
Y, Pb, Pr
Not used
Power connector — Plug a standard IEC power cord into this
connector to connect the CVC 200 to a 100 to 240VAC, 50 Hz or
60 Hz power source.
a
Input connectors — Connect a component video input device
(HDTV, W-VHS [Y, Pr, Pb], SMPTE [Y, R-Y, B-Y]), Betacam®
[Y, R-Y, B-Y]) or an RGsB input device to these female BNC
connectors. Use high-resolution cable, such as Extron’s BNC-
4 mini HR, RG59/HR, or RG6/SHR cable. Connect the input
device as shown in figure 4.
b
Output connectors — Connect an RGBHV or RGBS display to
these female BNC connectors. Use high-resolution cable, such
as Extron’s BNC-4 or BNC-5 mini HR, RG59/HR, or RG6/SHR
cable. Connect the display as shown in figure 5.
d
Y, PB, PR
video
Y, B-Y, R-Y
video
RGBHV
video
P
R/R
P
R/R
Y/G
Y/G
P
B/B
P
B/B
(R-Y)
(B-Y)
R
S
G
B
H
H
V
V
RGsB
(SOG)
video
RGBS
video
P
R/R
Y/G
P
B/B
R
S
G
B
Figure 4 — Input connections
Figure 5 — Output connections
3
CVC 200 • Cable Connection and Rate Selection
CVC 200 • Rate Selection
4
Specifications (Cont’d)
General
Power ............................................. 100 VAC to 240 VAC, 50/60 Hz, 12 watts,
internal, autoswitchable
Specifications
Specifications
Video
Temperature/humidity................ Storage -40° to +158°F (-40° to +70°C) / 10% to
90%, noncondensing
Operating +32° to +122°F (0° to +50°C) / 10% to
90%, noncondensing
Rack mount.................................... Yes, with optional rack shelf,
part #60-190-01 or #60-604-01
Gain ................................................ Unity
Bandwidth ..................................... 55 MHz (-3 dB)
Video input
Number/signal type..................... 1 component video [HDTV, W-VHS (Y, Pr, Pb),
SMPTE (Y, R-Y, B-Y), and Betacam®
Enclosure type .............................. Metal
(Y, R-Y, B-Y)] or RGsB
Enclosure dimensions .................. 1.6” H x 8.75” W x 9.4” D
(1U high, half rack wide)
4.1 cm H x 22.2 cm W x 23.9 cm D
(Depth excludes connectors.)
Product weight .............................. 2.8 lbs (1.3 kg)
Shipping weight ........................... 5 lbs (3 kg)
Connectors .................................... 3 BNC female
Nominal level ................................ 1V p-p for Y of component video
0.3V p-p for R-Y and B-Y of component video
0.7V p-p for PB PR
Minimum/maximum levels........ Y: 0.5 V to 1.5 Vp-p with no offset at unity gain
PB PR: 0.4 V to 1.0 Vp-p with no offset at unity
gain
Impedance ..................................... 75 ohms
Vibration ........................................ ISTA 1A in carton
(International Safe Transit Association)
Listings............................................ UL, CUL
Compliances................................... CE
Horizontal frequency.................... 15.75 kHz to 100 kHz according to selected mode
Vertical frequency.......................... 60 Hz
MTBF............................................... 30,000 hours
Warranty ........................................ 3 years parts and labor
Return loss ..................................... <-25 dB @ 5 MHz
DC offset (max. allowable)........... 2 V (maximum)
N
Video output
All nominal levels are at 10%.
Number/signal type..................... 1 RGBHV, RGBS
Connectors .................................... 6 BNC female
Nominal level ................................ 0.7 Vp-p for RGB
Minimum/maximum levels........ RGB: 0.4 V to 1.0 Vp-p
Impedance ..................................... 75 ohms
N
Specifications are subject to change without notice.
Return loss ..................................... <-30 dB @ 5 MHz
DC offset ........................................ 0.1 V with input at 0 offset
5
CVC 200 • Specifications
CVC 200 • Specifications
6
|