Eiki Projector AH 45201 User Manual

WARNING:This installation manual is for use by  
service personnel. Please be aware that the  
manufacturer cannot be responsible for breakage  
or damage incurred due to improper installation of  
this lens or use of the projector.  
1
2
Loosen the lamp replacement  
screw (1) that fastens the lamp  
unit cover, and remove the lamp  
unit cover by sliding in the direc-  
tion shown by the arrow (2).  
Remove the mounting screws of  
the top cover.  
Installation Manual  
When replacing the lens, please have the lens replaced by  
the store of purchase or an EIKI Engineering certified  
service workshop.The inside of the projector contains high-  
voltage parts that can be extremely dangerous. Never  
attempt to replace the lens by yourself.  
AH-45201  
AH-45301  
Always make sure to turn off the main power and unplug  
the power cord before replacing the lens.  
Be careful not to allow any screws to drop inside the projector  
while working. This can cause a fire, electrical shock or  
malfunction.  
AH-45401  
Lamp replacement  
Top cover  
Lamp unit cover  
screw  
(Only for EIP-4500L)  
Do not attempt to replace the lens while the projector is  
suspended from the ceiling. The lens may fall out of the projector  
resulting in injury.  
AH-51401  
2
(Only for EIP-5000L)  
Before replacing the lens, return the lens shift to the  
position shown below. (The lens shift is adjusted to the  
position shown below when shipped from the factory.)  
V (vertical) shift: Uppermost position  
1
AH-45501  
AH-45601  
AH-45701  
H (horizontal) shift: Middle position  
When replacing the lens, use a commercially available  
screwdriver that satisfies all of the conditions indicated below.  
Type 2 Philips head screwdriver  
Length of protruding section: min. 180 mm (10")  
Magnetized  
Mounting screws  
3
4
5
6
(When the lens being removed is the  
AH-45401 (EIP-4500 standard lens) or  
AH-51401 (EIP-5000 standard lens))  
Unplug the cable connector (1)  
and remove the top cover (2).  
Release the tabs while pulling up  
on the lens cover, and then pull  
it out towards you.  
Unplug the cable connector.  
Remove the lens ring by turning  
in the direction shown by the ar-  
row.  
1
2
Cable  
Cable connector  
connector  
Tabs  
Lens cover  
AH51401_Inst_Manual_E.p65  
1
06.12.27, 11:54 AM  
 

Ei Electronics Smoke Alarm Ei100C User Manual
Escient Stereo Receiver AVX User Manual
Euro Pro Electric Grill K4820H User Manual
Everpure Water System EV9107 23 User Manual
Evo Fitness Elliptical Trainer Rev 300 User Manual
Excalibur electronic Clock Radio RD501 24 User Manual
Extron electronic Network Card DVID SL 15 User Manual
Fisher Price Baby Toy X6842 User Manual
Friedrich Thermostat RT6 User Manual
GE Microwave Oven 164D2966P143 User Manual