ZCG3500DSS – GE Monogram Built-In Compactor
Dimensions and Specifications (in inches)
This Monogram compactor has a
black control panel.
Additional Specifications
A 115 Volt, 60 Hz. power supply is required. An individual properly grounded
branch circuit protected by a 15- or 20-amp circuit breaker or time delay fuse
is recommended. Install a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical outlet location is critical for proper cord
storage when compactor is installed.
34"-35"
The adjustable base allows the toekick
depth to match surrounding cabinetry.
This compactor is designed as a
built-in appliance only. It may be
12-1/8"
min.
20-1/4"
located in any convenient space under If the compactor is to be located in or near a corner of base cabinets, allow
a countertop. DO NOT OPERATE FREE- 2" minimum clearance from the corner to prevent interference with adjacent
STANDING because the compactor
will tip over when the drawer is
pulled out.
door handles.
34"
min.
adj. to
35"
Note:
If cord is to be plugged in directly behind compactor add 2-1/2" to overall
depth in order to allow proper clearance for the electrical cord.
22-1/2" min.*
max.
*Add 2-1/2" to
depth if outlet
is located directly
behind compactor
12"
Adjustable base
2-3/4" to 4-1/4"
Listed by
Underwriters
Laboratories
R
®
™
For answers to your Monogram, GE Profile or
®
GE appliance questions, visit our website at
GEAppliances.com or call GE Answer Center
®
Specification Revised 9/03
service, 800.626.2000.
160005
|