FSEC/FSGC748GF
FSE/FSG748GF
OPERATING INSTRUCTIONS
AUTOMATIC
AUTOMATIC
NORMAL
DRY
PERM PRESS
REGULAR
NORMAL DRY
NORMAL
DRY
TIMED DRY
REGULAR
MOISTURE SENSOR
INTERIOR DRUM LIGHT
AUTOMATIC
DELICATE
R
6. Turn cycle selector clockw ise to desired setting.
AIR FLUFF-NO HEAT setting tumbles the load without
heat. Use AirFluffto freshen clothing, pillowsorblankets,
or to dust draperies.
Before Operating Your Dryer
Read your dryer Ow ner's Guide. It has important
safety and warranty information. It also has many
suggestions for best drying results.
7. Start dryer. Turn the Turn to Start controlclockwise
to ON. Hold for 1-2 seconds and release.
8. When Cycle Signal control is on, a signal w ill
sound at the end of the cycle.
Cycle Selection
To reduce the riskoffire, electricshock,
or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS in your dryer Owner's Guide before
operating this appliance.
9. Remove items immediately and hang or fold.
10. Clean lint screen after every load.
Turn cycle selector clockwise to desired cycle and
setting.
Each cycle ends with a cool down period. The heat
automaticallyturnsoffand the load continuesto tumble
during the cooldown period. Thisreduceswrinkling and
makes items easier to handle during unloading.
Temperature Selection
Alw ays follow directions on fabric care labels.
Operating Steps
Read Drying Procedures in your Owner's Guide. It
Drying time varies depending on size and dampness of
load, weight and fabric type. Room temperature and
humidity, type ofinstallation and electricalvoltage orgas
pressure can also affect drying time.
explains these operating steps in detail.
To avoid fire hazard, do not use heat to
dry items containing feathers or down, foam rubber,
plastics, or similarly textured, rubber-like materials. Use
Air Fluff-No Heat setting only.
1. Prepare items for drying.
2. Check that lint screen is clean and in place.
3. Load the dryer. If desired, add a dryer fabric
softener sheet.
The REGULAR-HIGH HEAT, PERM PRESS-MEDIUM
HEAT,andKNITS/DELICATES-LOW HEATtemp-erature
settings may be used with any cycle setting. The AIR
FLUFF-NO HEAT setting can be used only in the Timed
Dry cycle.
4. Close the dryer door.
5. Set Dry Temperature and Cycle Signalcontrols.
(continued, reverse side)
Printe d in U.S.A.
P/ N 131713000 (9803)
"
Cut along this edge to separate English from other languages. "
|