X5855
Please keep this instruction sheet for future reference,
as it contains important information.
Requires one “AA” (LR6) alkaline battery (not included).
Adult assembly is required. Tool required for battery installation:
Phillips screwdriver (not included).
Wipe this toy with a clean, damp cloth. Do not immerse.
This toy has no consumer serviceable parts. Do not take apart.
fisher-price.com
Assembly
Handle
Base
• Insert the handle into the base. Push to “snap” in place.
• Fit the ramps onto the base, as shown.
3
Decoration
• Place the labels exactly as shown in the illustrations.
• For best results, avoid repositioning a label once it has been applied.
9
1
2
10
8
11
6
3
4
7
5
4
Rev ‘Em Up!
Press the go button to race
the car down the ramps
and hear more sounds!
Pump the handle to “pump up” the car.
For best performance, use on a hard,
flat surface.
Hint: Pump the handle up to 10 times to
make your car go even faster!
Press
Slide the power switch
ON or OFF
.
Press
Insert the pins in
the base into the
sockets in the back
of the vehicle.
Press
Press the button
on the gas pump
or the air ratchet
for sounds!
• If this toy begins to operate erratically, you may need to reset the
electronics. Slide the power switch off and back on.
• When sounds become faint or stop, it’s time for an adult to change
the battery.
• This product is not recommended for use on loose dirt or
wet surfaces.
• For best performance, periodically wipe the rear wheels with
a clean cloth.
5
FCC Statement (United States Only)
CONSUMER ASSISTANCE
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and,
if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
Mattel Europa B.V., Gondel 1, 1186MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
ICES-003
• This Class B digital apparatus
complies with Canadian ICES-003.
• Operation is subject to the following
two conditions: (1) this device may
not cause harmful interference and
(2) this device must accept any
interference received, including
interference that may cause
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
undesired operation.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications
not expressly approved by the
manufacturer responsible for
NMB-003
• Cet appareil numérique de la classe
B est conforme à la norme NMB-003
du Canada.
• L’utilisation de ce dispositif est
autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire
de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter
tout brouillage radioélectrique reçu,
même si ce brouillage est susceptible
de compromettre le fonctionnement
du dispositif.
compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
©2012 Mattel. All Rights Reserved.
PRINTED IN CHINA
X5855pr-0920
|