VICTOR SERIES ALUMINUM WATER PUMP
For 1958-1979 361-440 (Incl. 426 Hemi) and 1969-1985 318-360 Chrysler V8s
Part #8814, 8824, 8877 & 8887
®
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common
tools and procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable
performing this installation, it is recommended to have the installation completed by a qualified mechanic. If you have any questions,
please call our Technical Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday.
IMPORTANT NOTE: Proper installation is the responsibility of the installer. Improper installation may result in poor
performance and engine or vehicle damage.
DESCRIPTION: The Victor series are heavy duty water pumps for both street and racing applications. These pumps are a direct
replacement for the original equipment pump to provide compatibility with all accessories and pulleys. It offers weight savings along
with increased durability and cooling potential. It is a standard rotation water pump for Chrysler Wedge (B & RB), 426 Hemi and Small
Block engines and should not be used on engines converted to a serpentine belt pulley system.
INSTALLATION: Installation is the same as for orignal equipment water pumps. Consult service manual for specific procedures.
CAUTION: Be sure that the fan bolts don’t protrude through the hub so far that they hit the water pump housing. Check closely
for any interference with drive belts; some filing for clearance may be necessary with some applications. Verify that the radiator
fan is properly balanced. Imbalanced fans can cause severe damage and/or injury and will void your warranty.
WARNING
Incorrect alignment or an unbalanced condition puts excessive strain on the pump's shaft and/or bearing and will result
in early failure of the shaft and/or bearing. The balance of the assembly depends primarily upon the concentricity of
the fan clutch with the pump shaft. Concentricity is not assured when universal type clutches are used. The universal
fan clutch has a 3/4" pilot hole, so an adapter must be used when installing a water pump with a 5/8" shaft. This
adapter bushing is supplied with the unit. These adapter bushings add to the machine tolerances of the assembly, so
special care must be taken to maintain concentricity with the shaft and the clutch fan.
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 800-416-8628
Part #8814, #8824, #8877 & #8887
Rev. 5/09- AJ/mc
©2009 Edelbrock Corporation
Brochure #63-8814
|