Wireless Mic WMIC1 Quick Start Guide
1. Connect the Receiver to the USB Power adapter by the USB to DC Power ca-
ble . Use the DC port (13 , see below ) on the Receiver.
Pg 1 of 2
2. Plug USB Power Adapter into a 115 VAC power outlet.
3. Turn Receiver power (12) to ON. The green LED will come on and continue to
slowly blink.
4. Turn the switch (11) to 20dB / MIC
5. Press the Vol+ and Vol- ( 2 and 7 ) to get the display (5) to read 15.
6. Press the CH+ and CH- (4 and 9 ) to set the channel. A good choice is a chan-
nel of 50 or above to reduce the potential of any WiFi interference. The display
(5) shows the channel.
RECEIVER
7. Connect the 3.5 mm mini audio output port (6) with a 3.5 mm mini stereo cable
to the MIC input or audio input on a projector or a sound system. The audio out is
at line level.
Blank , closed port
Green LED—Status
Audio Output jack, 3.5 mm
Set switch to 20dB / MIC
Power switch ; set to ON
Power Input jack
Connections for a typical Dukane projector
Connect the audio cable to MIC port on the projector.
Go to the projector menu and set mic level High;
ADVANCED MENU / AUDIO/ MIC LEVEL / HIGH
Then set the MIC VOLUME to midrange , about 30;
ADVANCED MENU / AUDIO/ MIC VOLUME / Set midrange
For the projector to have the sound system operating when the lamp is off set the Standby
Mode to Normal ;
ADVANCED MENU / STANDBY MODE / NORMAL
Projector speakers ; If using the projector speakers be sure they are turned ON.
Also projector volume needs to be set at a suitable level.
WMIC1_Quick Start Guide Rev 01
|