V90181
INSTALLATION INSTRUCTIONS
STEALTH GRAZE
U
FIXTURE MOUNTING
L
R
C
US
Avoid Fire or Electric Shock
*Installation Instructions for qualified electricians only.
*Install per National Electrical Code and local regulations.
*Read Installation Instructions completely before installation.
*Failure to follow Installation Instructions may void warranties.
FIXTURE MOUNTING
Thumb Screw
1. Before Stealth Graze can be installed, blocking should be
installed above ceiling around the fixture. (Figure 1)
Thermal
Bracket
Vertical Wall
(Grazed Surface)
Thermal
Protector
Ceiling
Blocking
FIGURE 3
4a.If two or more Stealth Graze Housings are being used, align
Housings into Ceiling, butting fixtures end to end tightly. Place
two (2) Connecting Screws through Connecting Holes on
Housings, and secure with Connecting Nuts. (Figure 4)
FIGURE 1
2. The Trim of the Stealth Graze must now be removed so that
access can be gained to the Thermal Protector. This step may
be skipped if blocking is not in the way of the Thermal
Protector or a different mounting method is being used. Place
the Utility Wedge between the Trim and the Plaster Frame and
push straight up until the Trim pops out. (Figure 2) Do not
bend the Utility Wedge while in the Fixture, as it might break.
4b.Once the Fixture is placed into the ceiling, it can be secured
using countersunk screws. Fixture should be mounted by
screwing through the Plaster Frame (screw holes are already
countersunk) and into the blocking. (Figures 5 & 6) If additional
screw locations are needed, there is a screw line in the Plaster
Frame extrusion to facilitate this process.
Housing
Thermal Protector
Connecting Screws
Connecting
Holes
Housing A
Trim
Plaster Frame
Utility Wedge
FIGURE 2
3. Once the Trim is removed, the Thermal Protector should be
pulled inside the Housing so that the Fixture will slide past
the Blocking. To do this, reach inside the Housing, unscrew
the Thumb Screw, and pull the Thermal Bracket (with the
Thermal Protector attached) into the Housing. (Figure 3)
The Fixture can now be hoisted into the ceiling for mounting.
Housing B
Connecting Nuts
FIGURE 4
7945 Orion Avenue, Van Nuys, CA 91406 818-349-3030/ 800-356-3030 FAX 818-349-3031
RSA Lighting
|