Code Alarm Automobile Alarm CATX130 User Manual

Model CATX130  
Programming Guide  
The keychain transmitters included with the system have been pre-programmed at the factory,  
with each button pre-assigned to control a specific function of the system.  
The system will store codes from up to 8 different transmitters. If a 9th transmitter is  
programmed to the system, then the first transmitter programmed to the system will be  
erased from the system’s memory.  
To program new or additional transmitters, the alarm must be disarmed and out of valet mode:  
1. Open the drivers door (verify that the vehicle’s interior light turns on.  
2. Turn the ignition key to the ON or RUN position.  
3. Press and hold the emergency override button  
3a. After 10 seconds the horn will honk three (3) times. This indicates  
that the system has entered transmitter programming mode.  
4. Release the emergency override button.  
5. Press the LOCK icon button on the remote transmitter to be programmed.  
5a. The horn/siren will sound 1 time, indicating that the system has  
“learned” that remote transmitter.  
6. Repeat step 5 for any additional remote transmitters.  
Deleting Lost or Stolen Remote Controls from Your System  
If one of your remote controls is lost or stolen, follow these instructions IMMEDIATELY to  
remove the control code from your system.  
1. Have all remaining remote controls available.  
2. Enter the control programming mode by following steps 1 - 5 of Adding Remote Controls  
to Your System.  
3a. If you have only one remaining remote control, press the  
LOCK button on that remote control eight (8) times, pausing  
at least 1 second in between each press. The horn must  
“honk” each time you press the LOCK button.  
3b. If you have two remaining remote controls, press the LOCK  
button on each remote control four (4) times, pausing at least  
1 second in between each press. The horn must “honk” each  
time you press the LOCK button.  
3c. If you have three remaining remote controls, press the  
LOCK button on two of the remote controls three (3) times, then press the  
LOCK button on the remaining remote control twice. Pause at  
least 1 second in between each press. The horn must “honk”  
each time you press the LOCK button.  
4. Turn the vehicle ignition off to exit the programming mode. When you are finished, the lost  
or stolen remote control will no longer operate your system.  
 

Continental Electric Coffeemaker CE23601 User Manual
Cooper Lighting Work Light RD Series User Manual
Cub Cadet Snow Blower 521E User Manual
Curtis CRT Television TV2010 User Manual
Dukane Projector 8111H User Manual
Dynacord Speaker MX 12 User Manual
Edelbrock Automobile Parts 17000 User Manual
EverFocus Camcorder 520TVL 380TVL User Manual
GE Washer PFWS4600L User Manual
Gitzo Camcorder Accessories G1228LVL User Manual