Clarion Car Video System HRM100 User Manual

INSTALLATION INSTRUCTIONS  
HRM100  
C
Universal Headrest Mount for VMA6491/VMA7191  
The HRM100 is engineered to be installed into factory headrests while retaining the factory cosmet-  
ics. It is designed to fit Clarion monitors (VMA6491 or VMA7191) for rear passenger entertainment.  
Please follow the directions carefully.  
Clarion Monitor Headrest Shroud Preparation  
1. Remove the headrest from the vehicle.  
2. Using scissors, cut along the dotted lines of the provided headrest template.  
Note: Lay the template on headrest or seatback and verify fit and size.  
Make sure you verify the fit before proceding to the next step.  
3. Lay the template on the headrest or seatback. Carefully mark the cutout opening onto the  
headrest. Using a sharp utility knife, carefully cut the bezel opening and remove the material.  
Note: Carefully remove the foam and locate the metal headrest supports.  
4. Carefully cut an access hole for the video and power cables on the bottom of the headrest.  
5. Locate the metal headrest supports and insert the tie straps around the metal supports on all four  
corners.  
6. Slide the tie straps through the bezel openings. Once all tie straps are through the bezel, gently  
adjust tie straps one at time until headrest bezel is secured onto the headrest.  
Pre-Wiring of the Monitor  
1. Carefully run the video and power connections up the seat back and make an access hole on the  
top portion of the seatback.  
Seat Re-assembly  
1. Re-install the headrest onto seatback.  
Note: Do not re-install completely  
2. Run the video and power cables from seatback  
opening into the headrest wiring opening.  
Monitor Wiring and Mounting  
1. Insert the spacer into headrest bezel.  
2. Connect the video and power connections  
from the bezel to the monitor.  
3. Test the monitor for functionality before  
proceeding to the next step.  
3. Carefully tuck the cables into the headrest bezel.  
4. Gently press the monitor into place until it is flush  
with the bezel  
5. From the underside, through the access hole,  
carefully insert provided bolt and secure the  
monitor into place.  
Important Note  
HRM100 is intended for rear passenger entertainment only.  
Clarion Corporation of America, Gardena, CA  
 

Code Alarm Automobile Alarm CA 120 User Manual
Craftsman Lawn Mower 37435 User Manual
Creative Labs Speaker System P380 User Manual
Crock Pot Slow Cooker 08EM1 9100050002444 User Manual
Crosley Washer Dryer 1P N13488880 User Manual
Exmark Automobile Parts 920000 User Manual
Fostex DJ Equipment LM16 User Manual
Frigidaire Convection Oven FGB24T3EB User Manual
Frigidaire Cooktop FGEC3045K User Manual
GE Ventilation Hood JV394 User Manual