INSTALLATION INSTRUCTIONS
FDP SERIES
SMALL FLAT PANEL DISPLAY
DUAL SCREEN POLE MOUNT
Exclusive Q2™ Mounting System
Prior to assembly, unpack carton completely and verify contents.
If you are missing any of the following components, please contact Customer Service at 1-800/582-6480.
Figure 1
(2) FDP Pole-Mounting Bracket Half
(2) ¼-20 X 4.25” Hex Bolt
(2) ¼” Flat Washer
(8) 10-24 X 1.00 Thread Forming Screw
(8) ½” X ½” Nylon Spacer
BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY
The FSP will fit on any 1/1/2” to 2” O.D. pipe including 1 ½”NPT.
Flat Panel Displays are Extremely Fragile.
If Monitor Uses a Screw Size Other Than M4 X 10mm (M4 X 20mm),
DO NOT USE M4 Screws Provided. Monitor Damage Could Occur.
CAUTION!
Interface Bracket Installation:
1. See installation procedures accompanying your mounting bracket.
Optional Latching Flag Placement:
1. Remove Phillips head screw, Nylock nut and latching flag (see Figure 2).
2. Reposition latching flag and secure using Phillips head screw, Nylock nut.
Remove screw
and nut
Move latch
Figure 2
8803-000033
01/26/04
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: 1-877-894-6918, Email: [email protected]
|