(typical)
CHANNEL
VISIONTM
12 VDC
30 kHz - 56 kHz
16
500 ft.
Specifications subject to change without notice.
CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in
material or workmanship which occurs during normal use of this
product with new or rebuilt parts, free of charge in the USA, for two
years from the date of original purchase. This is a no hassle warranty
with no mail in warranty card needed. This warranty does not cover
damages in shipment, failures caused by other products not supplied
by Channel Vision Technology, or failures due to accident, misuse,
abuse, or alteration of the equipment. This warranty is extended only
to the original purchaser, and a purchase receipt, invoice, or other
proof of original purchase date will be required before warranty
repairsareprovided.
HANNEL
C
TM
ION
S
I
V
Mail in service can be obtained during the warranty period by calling
(800) 840-0288 toll free. A Return Authorization number must be
obtained in advance and can be marked on the outside of the shipping
carton.
This warranty gives you specific legal rights and you may have other
rights (which vary from state to state). If a problem with this product
develops during or after the warranty period, please contact Channel
Vision Technology, your dealer or any factory-authorized service
center.
CHANNEL VISIONTM
234 Fischer Avenue Costa Mesa, CA 92626
(714) 424-6500 (800) 840-0288 (714) 424-6510 fax
500-073 rev E
© 2004 Channel Vision Technology
... Table top IR Receiver. Can be
placed on any flat surface such as a TV or
entertainment center.
... Stick type IR receiver with variable
field of view. An adjustable blinder swivels
around the IR pickup to prevent interference
from light sources that may cause erroneous IR
signals.
... Tube type IR receiver with variable
field of view. The IR pickup slides in and out of
the tube to adjust the field of view.
... Single head IR emitter with expansion
jack. As many as 3 units can be chained
together and connected to a single emitter
output.
HANNEL
C
T
M
ION
S
I
V
HANNEL
C
T
M
ION
S
I
V
... Universal remote control. Learns IR
codes for up to 6 sources.
Receiver
... IR receiver connecting block. Allows
8 IR receivers to be connected in parallel so that
one set of wires can be connected to the P-1205
CHANNEL VISIONTM
Central
C-1201
Sat radio
DVD player
Only 1 power supply
is needed.
Sat radio
DVD player
The diagram shown above, will create 2 IR zones that will allow for
independent control of identical devices from the same manufacturer.
The zone IR emitters will only respond to signals from the IR receiver
that is in the same zone. The global IR emitters will respond to
signals from any IR receiver in the system.
CD player
6
3
A basic IR system, like the one shown below, is often used when
audio/video devices are stored inside a closed cabinet and are out of
the line of sight. The IR receiver is placed outside the cabinet so that
the remote control can be point directly at it. It will detect the IR
signals and route to the P-1205, which in turn sends them to the
emitter outputs.
Additional IR receivers
can be connected as
needed.
CHANNEL VISIONTM
Central
C-1201
HANNEL
C
T
M
ION
S
I
V
HANNEL
C
TM
ION
S
I
V
Sat radio
DVD player
Sat radio
CD player
DVD player
CD player
Receiver
Receiver
The diagram above illustrates how to create an IR system with IR
receivers in several different rooms in the house. Systems like this
may include several different styles of IR receivers depending on the
specific application in each room.
4
5
|