The M319 is compatible
with these Califone UHF products.
Beltpack Transmitter
Owner’s Manual
Beltpack Transmitter
M319
Thank you for choosing the M319 Beltpack
Hi/Low RF
3.5mm
transmitter. It provides wireless audio
transmission to the Califone® PA919SD,
PA919, PA919PS PA systems and can be
used for indoor and outdoor applications.
Power
Mic In
Channel
Up/Down
Volume
We encourage you to visit our website
to register your M319 at califone.com/
registratiom for its warranty coverage, and
while there sign up for our newsletter and
also learn more about the complete line of
Califone audio visual products including:
Portable and installed wireless PA systems,
multi-media players & recorders, headphones
and headsets, computer peripheral
NOTE:
There are two wireless 900MHz mic receivers on the
PA919SD and PA919 (single frequency on the PA919PS).
These frequencies are not compatible with any PA916 Series
PAs, or the M-316 or Q-316 microphones.
In the US, only the low power (5dBm) setting should be used
to comply with FCC Part 15 requirements.
M319
Owner’s
Manual
equipment, visual presentation products
and language learning materials.
Power
9V Battery
Compartment
Package Contents:
( 1 ) M319 16-Channel UHF Transmitter
( 1 ) User Manual
Califone® International Inc.
1145 Arroyo Avenue, # A • San Fernando, CA 91340 USA
Toll Free 800.722.0500 | Toll Free Fax 877.402.2248
International Customers call 818.407.2400 or Fax 818.407.2405
900MHz Frequency
califone.com | califonepro.com
April 2009
1
LM-316
Operating Instructions:
Product Compatibility
Returning your unit for service or repairs
Should your unit require service, contact your
dealer or our Customer Service Department
directly via email ([email protected]), or
by phone at 800-722-0500 / 818-407-2400 to
first obtain a Return Authorization (RA) number
before sending it back to Califone.
The M319 Beltpack Transmitter (and Q319
Microphone) are compatible with the PA919SD,
PA919, PA919PS PAs. They are not compatible
with the PA916 series PAs or the M-316 or Q-316
microphones.
The microphone frequency must first be set to
the same frequency as the receiving PA.
OE-316
HBM-316
1. Open th battery cover and insert a 9V battery
(not included) into battery compartment.
Close the battery cover.
Warranty Registration
2. Adjust the volume knob to minimum.
3. Connect one of the Califone microphones
(shown on pages 3 & 4) to the 3.5mm
mic input jack. The M319 can accept
dynamic or electret microphones.
4. Turn on the M319 power switch. The LCD
will display the current transmit channel.
5. To change the transmit channel:
The warranty for the M319 specifically
covers use in schools, churches, and business
& industry applications, unlike consumer
electronic products. This is critical to help avoid
lost class time due to “down”equipment and
helps stretch budgets.
Damage Requiring Service
The M319 should be serviced by
qualifed service personnel when:
CM-316
• Objects have fallen on it or liquid
has been spilled onto it
• It has been exposed to rain
• It does not appear to be operating
normally or exhibits a marked
change in performance
NM-316
Califone warrants the M319 to be free from
defective material and workmanship for one
year from the purchase date. Our “Project
Intercept”Customer Satisfaction program will
replace defective parts and repair malfunctioning
products under this warranty when the defect
occurs under normal use, provided the unit is
returned to our factory via prepaid transportation
only after the factory issues an RA
Specifications
•
Use a pen to hold the channel down
button for about 3 seconds.
Carrier Frequencies
Modulation
902 ~ 928 MHz (16 channels)
FM
±5KHz
* Since the PA919SD and PA919 each have
two built-in wireless receivers, make sure the
corresponding M319 (or Q319) transmitters are
set to different frequencies (one for
each channel).
•
The transmit channel will begin to flash
on the LCD.
• It has been dropped or the
enclosure damaged
Frequency Stability
Transmitting Power
Spurious Rejection
AF Modulation Depth
Volume Code Modulate Depth
AF Frequency Response
S/N
Distortion
Dynamic Range
Transmission Distances
•
•
Release the down button.
Switchable: 5dBm / 10dBm
>55dB
20K (AF=1KHz50MV)
3.5K ± 0.5K
80HZ~18KHz (±3dB)
>90dB
<1% (AF=1 KHz)
>90dB
High setting – approximately 200 feet
Low setting – approximately 40 feet
DC 6V~9V
<42MA
FCC, RoHS
Then use the up/down buttons to change
to the desired transmit channel.
After about 3 seconds the transmit
channel will be set and the channel on
the LCD display will be solid.
All shipments to Califone must include the
RA number clearly marked on the exterior of
the shipping carton and must shipped prepaid.
C.O.D. shipments will be refused and returned
at your cost.
•
Power Adjustment (Optional):
(Return Authorization) number which
must be clearly written on the outside
of the shipping box.
1. The power output of the M319 can be
adjusted between low (5mW) and high
(10mW) power settings, depending on the
level of interference or the range of required
transmission (low power up to 40’/high
power up to 200’). When there may be
other PA products used in neighboring or
adjoining rooms, using the low setting will
reduce the occurrence of experiencing
any interference.
•
Make sure the transmit channel is not being
used by any other transmitters in the area or
there could be audible interference. If there
is any interference or distortion, try using a
different channel.*
Servicing
All Damage Claims Must Be Made
With The Freight Carrier
Notify the freight carrier immediately if you
observe any damage the shipping carton or
product. Repack the unit in the carton and
await inspection by the carrier’s claim agent.
Notify your dealer of the pending freight claim.
The user should not attempt to service
the M319 beyond that described in these
operating instructions.
Operating Voltage
Current
Safety / Compliance Testing
Battery
Operational Temperature
Input Jack
6. Set the Califone receiver to the same
channel as the transmitter.
7. Turn on the receiver and first adjust its
volume level.
8. Then turn the M319 on and adjust its volume
level to the desired level.
Requires 9V battery (not included)
-10oC to +60oC
3.5mm
2. With the power off, simply change the
transmit power by moving the switch to
the desired setting.
visit us online at califone.com | califonepro.com
visit us online at califone.com | califonepro.com
3
4
2
M319_manual.indd
2
6/22/09 1:11 PM
|