VOYAGER® 4.5 INCH FAMILY TELESCOPE
MODEL 78-2010
Never Look Directly At The Sun With Your Telescope
Permanent Damage To Your Eyes May Occur
SHOULDER STRAP ATTACHMENT (IF DESIRED)
1. Remove the Adjustable Shoulder Strap (8) (not shown) from the carton.
2. Attach one end of the Adjustable Shoulder Strap (8) to the Forward Clips (6) on the side of
the Telescope Body (2).
3. Attach the other end of the Adjustable Shoulder Strap (8) to either the other Forward Clip (6)
or the Rear Clip (7), whichever provides the most comfortable position. Adjust the Shoulder
Strap (8) and enjoy.
TELESCOPE USE
SELECTING AN EYEPIECE:
1. You should always start viewing with the lowest power eyepiece, which in this case is the 31
mm lens. Note: the base power of each eyepiece is determined by the focal length of the
telescope objective element, which for this model is 500 mm. A formula can be used to
determine the power of each eyepiece: telescope OBJECTIVE mirror focal length
EYEPIECE focal length = MAGNIFICATION (e.g. Using the 31 mm lens, the calculation
would look like this: 500 mm ¸ 31mm = 16x or 16 power.) In addition, the 5mm eyepiece
will provide a magnification of 100x or 100 power.
2. Offered as an accessory for this telescope is a Barlow lens (model #78-0105). Barlow lenses
are used to double or triple the power of your telescope by placing your Barlow between the
focusing tube and the eyepiece. Using the example above, a 2x Barlow lens would give you a
total power of 32x or 32 power. (16 x 2 = 32x or 32 power). The 2x Barlow Lens (model #78-
0105) would provide a 200x or 200 power magnification when used in conjunction with the
5mm eyepiece. Other accessories available include a 9mm eyepiece (model #78-0101) that
would give you 56x or 56 power and a standard camera adapter (model #78-0104) for
photographing the night sky.
FOCUSING TELESCOPE:
1. After inserting the eyepiece, aim the main telescope tube at a land-based target at least 200
yards away (e.g. A telephone pole or building). Fully extend focusing tube by turning Rack &
Pinion Focusing Mechanism (4)
2. While looking through selected eyepiece (in this case the 31 mm), slowly retract focusing
tube by turning Rack & Pinion Focusing Mechanism (4) until object comes into focus.
COLLIMATING THE SECONDARY MIRROR
Good alignment or collimation of the telescope's optical components will guarantee the most
optimum viewing. This telescope body comes preassembled from the factory and
precollimated. Therefore collimation should not be required. However, due to its great
importance there are a few steps that you can take to ensure that your telescope is properly
collimated.
1. Remove the 1.25" Format Eyepiece (1) from the Rack and Pinion Focusing Mechanism (4).
2. Look into the Rack and Pinion Focusing Mechanism (4) with the eyepiece removed. You will
see the Secondary Mirror (5) located a few inches inside the end of the telescope tube nearest
the Rack and Pinion Focusing Mechanism (4). Since it is a mirror, you will see a reflection of
the large primary mirror. That mirror will show an image of the Secondary Mirror (5) and
your eye. Each image will be centered in a concentric set of images starting with the image of
the primary mirror, the Secondary Mirror (5), and your eye.
3. Please refer to the diagram to see what to expect.
Secondary Mirror Collimated
Secondary Mirror (Out of Alignment)
4. If the image of your eye is centered in the reflection of the Secondary Mirror (5), your
Secondary Mirror (5) is collimated. If it is off to one side, then secondary mirror adjustment
will be required. You will see three screw heads on the Secondary Mirror (5). They are
positioned 120 degrees apart. By adjusting these three screws very slowly and carefully, the
Secondary Mirror (5) will reflect an image of your eye that is perfectly centered in the
reflection of the Secondary Mirror (5). Once this is accomplished, your Secondary Mirror (5)
is now collimated.
5. Your telescope is now ready to deliver the best images possible.
Enjoying Your New Telescope
1. First determine your targeted object. Any bright object in the night sky is a good starting
point. One of the favorite starting points in astronomy is the moon. This is an object sure to
please any budding astronomer or experienced veteran. When you have developed
proficiency at this level, other objects become good targets. Saturn, Mars, Jupiter, and Venus
are good second steps to take.
2. Avoid the temptation to move directly to the highest power. The low power eyepiece will
give you a wider field of view, and brighter image--thus making it very easy to find your
target object. At this point with a focused image, you've passed the first obstacle. Once you
pass this step, you'll will enjoy the time spent with your telescope. Every celestial object you
center in the telescope will be easily focused, which is important for continuing your
exploration of the night sky.
3. The low power eyepieces are perfect for viewing the full moon, planets, star clusters,
nebulae, and even constellations. These should build your foundation. However, for more
detail, try bumping up in magnification to higher power eyepieces on some of these objects.
During calm and crisp nights, the light/dark separation line on the moon (called the
"Terminator") is marvelous at high power. You can see mountains, ridges and craters jump
out at you due to the highlights. Similarly, you can move up to higher magnifications on
the planets and nebulae. Star clusters and stars are best viewed through the low power no
matter what.
4. The recurring astronomical theater we call the night sky is an ever-changing billboard. In
other words, not the same movie plays all the time. Rather, the positions of the stars change
not only hourly as they seem to rise and set, but also throughout the year. As the earth orbits
the sun our perspective on the stars changes on a yearly cycle about that orbit. The reason
the sky seems to move daily just as the sun and the moon "move" across our sky, is that the
earth is rotating about its axis. As a result you may notice that after a few minutes or a few
seconds depending on what power you are viewing at, the objects in your telescope will
move. At higher magnifications especially, you will notice that the moon or Jupiter will
"race" right out of the field of view. To compensate, just move your telescope to "track" it in
the necessary path.
Helpful Hints
1. Your telescope is a very sensitive instrument. For best results and fewer vibrations set your
telescope up on a level location on the ground rather than your concrete driveway or your
wooden deck. This will provide a more stable foundation for viewing, especially if you've
drawn a crowd with your new telescope.
2. If possible view from a location that has relatively few lights. This will allow you to see
much fainter objects. You'd be surprised how much more you'll see from your local lake or
park when compared to a backyard in the city.
3. Using your telescope out a window is NEVER recommended.
4. View objects that are high in the sky if possible. Waiting until the object rises well above the
horizon will provide a brighter and crisper image. Objects on the horizon are viewed
through several layers of earth's atmosphere. Ever wonder why the moon appears orange as
it sets on the horizon. It's because you are looking through a considerable more amount of
atmosphere than you would directly overhead. (Note: If objects high in the sky are distorted
or wavy, you are probably viewing on a very humid night.) During nights of unstable
atmosphere, viewing through a telescope can be frustrating if not impossible. Astronomers
refer to crisp, clear nights as nights of "good seeing."
Where do I start?
Your Bushnell telescope can bring the wonders of the universe to your eye. While this manual is
intended to assist you in the set-up and basic use of this instrument, it does not cover everything
you might like to know about astronomy. The first thing you need to do is get a very simple star
chart and a flashlight with a red bulb or red cellophane over the end. For objects other than stars
and constellations, a basic guide to astronomy is a must. Some recommended sources appear on
suggested viewing. But, some of the standbys that you can see are:
The Moon--a wonderful view of our lunar neighbor can be enjoyed with any magnification. Try
viewing at different phases of the moon. Lunar highlands, lunar maria (lowlands called "seas"
for their dark coloration), craters, ridges and mountains will astound you.
Saturn--even at the lowest power you should be able to see Saturn's rings and moons. This is one
of the most satisfying objects in the sky to see simply because it looks like it does in pictures.
Imagine seeing what you've seen in textbooks or NASA images from your backyard!
Jupiter--the largest planet in our solar system is spectacular. Most noted features are its dark
stripes or bands both above and below its equator. These are the north and south equatorial
belts. Also interesting are Jupiter's four major moons. Pay close attention to their positions from
night to night. They appear to be lined up on either side of Jupiter.
Mars--The Great Red Planet appears as a reddish-orange disk. Look at different times of the year
and try to catch a glimpse of the white polar ice caps.
Venus--just like the moon, Venus changes phases from month to month. Some views of brilliant
Venus appear as if you were looking at a distant crescent moon.
Nebulae--The Great Orion Nebula is a very well known night sky object. This and many others
are brought to you by this telescope.
Star Clusters--View millions of stars densely packed in a cluster that resembles a ball.
Galaxies--One of the greatest and most interesting galaxies is our neighbor the Andromeda
Galaxy. Enjoy this and many others.
For further questions or additional information please contact:
Bushnell Sports Optics Worldwide
8500 Marshall Drive
Lenexa, KS 66214
ANSWERS TO COMMONLY ASKED QUESTIONS
1. The image I see in the telescope is upside down and
·
An upside-down and reversed image is a
reversed from right to left ?
common characteristic of most astronomical
telescopes. Since telescopes are used for
astronomical viewing orientation is not important.
2. How do I determine the power my telescope ?
·
The power of your telescope can be determine
by dividing the focal length of the objective lens by
the focal length of the eyepiece. The eyepiece focal
length is the number printed on the eyepiece. (For
example: 500 ¸ 5 = 100X)
3. Where do I find the Telescope Focal Length
·
The telescope focal length is the same focal
length as the objective focal length. For this
telescope it is 500mm. Telescope focal lengths
range from 500mm to 1200mm on Bausch & Lomb
and Bushnell telescopes.
4. What can I see with my telescope ?
·
Telescopes with power ranging from 16X to
50X can be used to view Star Clusters and Nebulae.
90X to 120X telescope can view galaxies. Most
planets can be seen at any magnification.
5. What do the numbers on the eyepiece mean ?
·
The numbers on the eyepiece represents the
“Focal Length” of the eyepiece.
TROUBLESHOOTING GUIDE
If after you have set-up your new telescope you are unable to see any objects, use this Quick
Reference guide to help you to understand the cause of the problem and quickly determine a remedy
1. I’ve completed the set-up yet I cannot see anything
·
·
Check to see if objective lens cover has been
removed.
Try to view an object that is 200 or more
yards away.
·
·
If there is more than one eyepiece included
with the telescope, use the lowest power
(highest number) eyepiece to begin viewing.
Use the Rack & Pinion Focusing Mechanism to
bring the object you are trying to view into
focus
Telescope LIFETIME LIMITED WARRANTY
Your telescope is warranted to be free of defects in materials and workmanship for the
lifetime of the original owner. The Lifetime Limited Warranty is an expression of our
confidence in the materials and mechanical workmanship of our products and is your
assurance of a lifetime of dependable service.
If your telescope contains electrical components the electronic components are warranted
to be free of defects in materials and workmanship for one year after the date of purchase.
In the event of a defect under this warranty, we will, at our option, repair or replace the
product, provided that you return the product postage prepaid. This warranty does not
cover damages caused by misuse or improper handling, installation or maintenance of the
product.
Any return made under this warranty must be accompanied by the items listed below:
1) A check in the amount of $15.00 to cover the cost of handling
2) Name and address for product return
3) An explanation of the defect
4) Product should be well packed in a sturdy outside shipping carton to prevent
damage in transit and return postage prepaid to the address listed below:
IN U.S.A. Send To:
Bushnell * 8500 Marshall Drive * Lenexa, Kansas 66214
IN CANADA Send To:
Bushnell * 25A East Pearce Street, Unit 1 * Richmond Hill, Ontario L4B 2M9
For products purchased outside the United States and Canada please contact your local
dealer for applicable warranty information. This warranty gives you specific legal rights.
You may have other rights which vary from country to country.
©2001 Bushnell Performance Optics
|