Lit. #: 91-0142/03-01
™
Harbormaster
35 x 60
Refractor
Telescope
Model 78-6035
Thank you for purchasing the Bushnell Harbormaster Telescope! Your new telescope has been designed and crafted
with the highest standards so that you may have years of enjoyment out of this wonderful window to the world. This
instrument comes complete with a vintage solid brass telescope crafted and polished to perfection, a solid wood tripod with
antique cherry finish, and a precision ground 60mm lens.
We would like to take this time to illustrate some of the
TELESCOPE ASSEMBLY
inherent traits of brass. Brass has a tendency to have minor
imperfections that should not be considered as defective.
Rather, these should be considered just for what they are--
common occurrences within the brass that add to the
character and antiquity of this product.
Remove all components from the carton and identify all
components. READ THROUGH ASSEMBLY INSTRUCTION
BEFORE YOU ASSEMBLE YOUR TELESCOPE.
It is our hope that you will enjoy and appreciate this fine
example of Old World craftsmanship and its authentic
1. Set-Up Tripod, Mount and Accessory Tray
• Locate the Altazimuth Yoke Mount (3). Note: B e f o r e
assembling tripod legs to Altazimuth Yoke Mount,
make sure the Accessory Tray Braces (7) face inward.
Locate the long bolts and washers from the hardware
pack. Position the mount over the Tripod Leg (5) as
shown (fig. 1) and align the holes in the Tripod Leg with
the holes in the mount. Insert the bolts through the holes
at the top of a Tripod Leg. A washer should be positioned
on both outer sides of the Tripod Leg. Attach a wing nut
to the bolt, but do not tighten it all the way. Repeat on the
remaining two Tripod Legs. Once you have attached all
Tripod Legs to the mount, securely tighten all wing nuts.
design for years to come.
STANDARD EQUIPMENT
• Solid Brass Telescope
• Solid Wood Tripod
• Altazimuth Yoke Mount
• Accessory Tray
• Hardware Pack:
Tripod leg: 3-2 1/2"bolts, 6-11/16 washers and 3-
wingnuts
Accessory tray: 3-1/2" bolts, 6-11/16" washers and 3-
wingnuts
Tripod Leg Lock Screws: 3 pc.
• Locate the Accessory Tray (8). Using the accessory tray
bolts, wingnuts and washers ( 3-2 1/2" bolts, 6-11/16
washers and 3 - wingnuts) connect the Accessory Tray
to the Accessory Tray Braces (7). Start with one Tripod
Continued on page 2
|