Bosch Appliances Home Security System VIPX 1600X FM4 User Manual |
VIP X1600 XFM4
VIP-X1600-XFM4A/VIP-X1600-XFM4B
en Quick Installation Guide
3
en | Scope of Delivery
VIP X1600 XFM4
2
Scope of Delivery
–
–
–
–
VIP X1600 XFM4A or VIP X1600 XFM4B encoder module
Two terminal blocks
Four screws for installation in the base
Quick Installation Guide
F.01U.088.580 | V4.0 | 2009.03
Quick Installation Guide
Bosch Security Systems
VIP X1600 XFM4
Unpacking | en
4
3
Unpacking
–
–
Please check the delivery for completeness and integrity.
Have your device checked by Bosch Security Systems if
you detect any damage!
Bosch Security Systems
Quick Installation Guide
F.01U.088.580 | V4.0 | 2009.03
5
en | Installing and Connecting
VIP X1600 XFM4
4
Installing and Connecting
4.1
Installing Modules
–
Insert the module into the guide rails of the first slot and
carefully push as far as it will go. If the first slot is already
equipped you can equip one of the other unused slots.
First, remove the respective cover plate by unscrewing the
screw and bending the cover plate upwards.
–
–
–
Insert the four screws provided in the bores on the module
and tighten.
After a module has been removed, you must reseal the
empty slot with a cover to ensure correct air circulation.
F.01U.088.580 | V4.0 | 2009.03
Quick Installation Guide
Bosch Security Systems
VIP X1600 XFM4
Installing and Connecting | en
6
4.2
Connecting Cameras
–
Connect one camera to each, the Video In 1 socket to the
Video In 4 socket.
Bosch Security Systems
Quick Installation Guide
F.01U.088.580 | V4.0 | 2009.03
7
en | Installing and Connecting
VIP X1600 XFM4
4.3
Alarm and Switch Connections
–
–
–
Connect the alarm lines to terminals lN1 to IN4 and GND
on the 8-pin terminal block.
Connect the relay lines to the two R1 terminals on the 8-
pin terminal block.
Secure the terminal block onto the left-hand part of the
male multipoint connector.
CAUTION!
A maximum load of 30 V and 500 mA may be applied to the relay
contact.
!
F.01U.088.580 | V4.0 | 2009.03
Quick Installation Guide
Bosch Security Systems
VIP X1600 XFM4
Installing and Connecting | en
8
4.4
Serial Interface
–
–
Connect the serial-connection lines to the corresponding
terminals on the 6-pin terminal block as required.
Secure the terminal block onto the right-hand part of the
male multipoint connector.
Bosch Security Systems
Quick Installation Guide
F.01U.088.580 | V4.0 | 2009.03
9
en | Installing and Connecting
VIP X1600 XFM4
4.5
Audio Connections
–
Use the Audio In and Audio Out sockets for the audio line
connections.
Line In
Input voltage 5.5 V
max.,
p-p
impedance 9 kOhm typ.
Output voltage 3 V at 10 kOhm /
Line Out
p-p
1.7 V
at 16 Ohm typ.
p-p
F.01U.088.580 | V4.0 | 2009.03
Quick Installation Guide
Bosch Security Systems
VIP X1600 XFM4
Configuration | en 10
5
Configuration
5.1
Assigning an IP Address
–
–
If you have not already done so, install the
Configuration Manager program from the product CD. The
product CD is included in the scope of delivery for the
base.
Start Configuration Manager when the installation is
completed. The network is scanned for compatible devices
automatically.
–
–
If the module is displayed in the list, right-click the entry
and then click Unit network settings... in the popup menu.
Enter the desired IP address (e.g. 192.168.0.116) in the
Unit IP address field and click OK. The module is rebooted
and the IP address is valid.
Note:
The module must be assigned a valid IP address and a matching
subnet mask to operate on your network.
Bosch Security Systems
Quick Installation Guide
F.01U.088.580 | V4.0 | 2009.03
11 en | Configuration
VIP X1600 XFM4
5.2
Testing the Configuration
–
–
Launch the Web browser and enter the IP address of the
that it is properly connected to the network.
Use the links at the top of the pages to navigate.
NOTICE!
Set the graphics card of the computer to 16-bit or 32-bit color
depth. Otherwise the computer cannot display the video
images.
F.01U.088.580 | V4.0 | 2009.03
Quick Installation Guide
Bosch Security Systems
Bosch Security Systems
Robert-Koch-Straße 100
D-85521 Ottobrunn
Germany
Telefon
Fax
089 6290-0
089 6290-1020
© Bosch Security Systems, 2009
|