™
Pet Hair Eraser
C O R D E D H A N D V A C U U M
U S E R ’ S G U I D E
8 7 R 4 S E R I E S 2 2 0 - 2 4 0 V
3
Safety Instructions
4
Product View
4
Assembly
4-5
Operations
5-6
Maintenance and Care
6
Troubleshooting
7
Consumer Services
7
Replacement Parts
8
Warranty
ug110-4076_87R4E_1008.indd
1
12/10/08 3:31:18 PM
IMPORTANT SAFETY INSTRUCTIONS
■
When using an electrical appliance,
basic precautions should be observed,
including the following:
Remove plug from electrical outlet before cleaning or
maintaining the appliance.
If the supply cord is damaged, it must be replaced by
the manufacturer or its service agent in order to avoid a
hazard.
Do not pick up toxic material (chlorine bleach,
ammonia, drain cleaner, petrol, etc.).
Do not use for any purpose other than described in
this User’s Guide.
■
READ ALL INSTRUCTIONS
BEFORE USING YOUR
UPRIGHT VACUUM.
■
■
■
■
Use only manufacturer’s recommended attachments.
Do not use with any opening blocked; keep free of
dust, lint, hair, and anything that may reduce air flow.
Keep appliance on a level surface.
Turn off all controls before unplugging.
Be extra careful when cleaning stairs.
This appliance is provided with double
insulation. Use only identical replacement parts.
Do not use without debris tank and/or filters in place.
Pay close attention when working
around children.
WARNING:To reduce
the risk of fire, electric shock,
or injury:
■
■
■
■
■
Do not use outdoors or on wet surfaces.
■
Do not leave machine when it is plugged in.
■
Do not use with damaged cord or plug.
■
If appliance is not working as it should, has been
■
■
dropped, damaged, left outdoors, or dropped into water,
return it to a service agent.
■
Do not handle unit with wet hands.
■
Do not pull or carry by cord, use cord as a handle, close
SAVE THESE
door on cord, pull cord around sharp corners or edges, run
appliance over cord, or expose cord to heated surfaces.
Do not unplug by pulling on cord. Unplug by
grasping plug.
■
INSTRUCTIONS.
THIS MODEL IS FOR HOUSEHOLD USE ONLY.
■
Do not run appliance over cord.
■
Do not handle plug or appliance with wet hands.
IMPORTANT
■
Do not expose hair, loose clothing, fingers or body
FOR OPERATION ON A 220-240 VOLT A.C. 50/60 Hz
POWER SUPPLY ONLY.
parts to openings or moving parts.
■
Do not pick up hot or burning objects such as
cigarettes, matches, or hot ashes.
Do not pick up flammable or combustible materials (lighter
fluid, petrol, kerosene, etc.) or use in the
presence of explosive liquids or vapour.
If your appliance is fitted with a nonrewireable BS 1363
plug it must not be used unless a 13 amp (ASTA approved
to BS 1362) fuse is fitted in the carrier contained in
the plug. (Spares may be obtained from your BISSELL
supplier). If for any reason the plug is cut off, it must be
disposed of, as it is an electric shock hazard should it be
inserted into a mains socket.
■
■
Do not use appliance in an enclosed space filled with
vapours given off by oil base paint, paint
thinner, some moth proofing substances, flammable dust,
or other explosive or toxic vapours.
■
Not intended for use by persons (including
children) with reduced sensory or mental capabilities, or
lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of
the appliance by a person responsible for their safety
■
Young children should be supervised to ensure that they do
not play with the appliance.
3
w w w . b i s s e l l . c o m
ug110-4076_87R4E_1008.indd
3
12/10/08 3:31:18 PM
Product view
Handle
Power Switch
Dirt Container
Release Latch
Dirt Container
Nozzle Release
Button
Flexible Rubber
Contour Nozzle
Power Cord with
Cord Wrap System
Filter Screen
HEPA Media Filter
Exhaust
Assembly
Your unit will come assembled and will require
no tools to put together.
Operations
Power switch
The power switch is located on the end of the curved
handle.
To turn hand vacuum ON ( I ), press up.
To turn hand vacuum OFF ( 0 ), press down.
2.
Cleaning with hard nozzle
1. Turn hand vacuum OFF.
2. Remove flexible rubber contour nozzle by
pressing down on round nozzle release
button.
3. Replace with hard nozzle by lining up the
bottom of nozzle to the bottom of the dirt
container. Pivot upwards to snap into place.
3.
4. Make sure the nozzle has snapped securely
into place before using.
w w w . b i s s e l l . c o m
4
ug110-4076_87R4E_1008.indd
4
12/10/08 3:31:19 PM
Operations
2.
Cleaning with flexible rubber contour nozzle
3.
1. Turn hand vacuum OFF.
2. Remove hard nozzle by pressing down on
round nozzle release button.
3. Replace with flexible rubber contour nozzle by lining
up the bottom of nozzle to the bottom of the dirt
container. Pivot upwards until it snaps into place.
4. Make sure the nozzle has snapped securely
into place before using
Emptying the dirt container
Empty the dirt container after each use. A
full dirt container may reduce suction or
performance of vacuum.
1. Turn hand vacuum OFF.
2. Unplug hand vacuum from electrical outlet.
3. Press dirt container release latch down to
disconnect dirt container and filter assembly
from the unit.
ATTENTION:
For best performance,
dirt container and filter
assembly should be
cleaned after every use.
4. Remove filter by grasping tabs on both sides
of filter frame and pulling away from the dirt
container. For best results, periodically tap filter
assembly against trash can to remove dirt that
has collected on the screen and filter.
3.
4.
6.
5. Empty dirt into trash can.
6. Replace filter assembly by aligning side
labeled “TOP” into top of dirt container.
Grasp filter tabs and press firmly to ensure
filter assembly is secure in dirt container.
5.
7.
NOTE: Make sure side of filter assembly
labeled "TOP" faces outward when inserting
filter assembly into dirt container.
7. Reattach dirt container to unit by aligning
bottom of dirt container to bottom of unit.
Pivot upwards and snap into place. Use one
hand to hold the unit and use the other hand
to clip the dirt container securely in place.
Maintenance and care
Cleaning the filter and screen
1. Turn hand vacuum OFF.
2. Unplug hand vacuum from electrical outlet.
3. Disconnect dirt container and filter assembly
4.
from the unit.
4. Remove filter by grasping tabs on both sides
of filter frame and pulling away from the dirt
container.
5
w w w . b i s s e l l . c o m
ug110-4076_87R4E_1008.indd
5
12/10/08 3:31:19 PM
Maintenance and care
Cleaning the filter and screen continued
5.
6.
5a.
5. Separate filter assembly by grasping tabs on
both sides of assembly and pull. For best results,
periodically tap filter and screen against trash
can to remove dirt that has collected.
6. Reconnect filter and screen by aligning
rectangular tab on filter with insert on screen.
Press together to ensure assembly is secure.
7. See page 5 to reattach dirt container.
NOTE: The dirt container and screen may be
rinsed with cold water. Ensure both are dry before
reinserting. DO NOT RINSE PLEATED FILTER.
Storage/Cord wrap system
A wrap is attached to the cord for quick and
easy storage.
1. To store the unit, turn hand vacuum OFF.
2. Unplug hand vacuum from electrical outlet.
Insert
Tab
3. Bundle cord, using wrap that is located on
cord, to store.
Nozzle Maintenance
Keep nozzles clean and free of debris.
1. Wipe nozzles clean with damp cloth.
Troubleshooting
Hand vacuum won’t run
Possible causes
Remedies
1. Power cord not plugged in
1. Check electrical plug
2. Thermal protector is activated
2. Turn OFF and unplug the unit. Empty dirt
container, clean filter and screen, and clear
any clogs. Wait 30 minutes before turning
the unit back on
Hand Vacuum won’t pick up or low suction
Possible causes
Remedies
1. Dirt container not installed properly
1. Check assembly of dirt container making
sure it is snapped in
2. Dirt container is full
2. Empty dirt container and reattach
3. See instructions above. Replace filter if needed
4. Wipe tools clean with damp cloth
3. Filter or screen is dirty
4. Nozzles are clogged with debris
Other maintenance or service not included in the manual should be performed by an
authorized service representative.
Please do not return this product to the store.
w w w . b i s s e l l . c o m
6
ug110-4076_87R4E_1008.indd
6
12/10/08 3:31:19 PM
BISSELL Consumer Services
If your BISSELL product should require service:
In the UK, Australia or New Zealand, call BISSELL Consumer Services at the numbers below and we will give
you the location of a BISSELL Authorized Service Center in your area. For all other countries, contact your local
in country distributor for questions, service, or repair.
If you have questions about your warranty or need replacement parts please contact the numbers below.
For UK inquiries:
For Australian inquiries:
Monday - Thursday 9 am — 5 pm
Friday 9 am — 4 pm
Monday - Friday 9 am — 5 pm
BISSELL AUSTRALIA PTY LIMITED
Unit 35
BISSELL Homecare (Overseas) Inc.
The Boat Yard
15 Ricketts Road
Mount Waverley, Victoria 3149
Australia
105 Straight Road
Old Windsor
Telephone: 1-800-811-183
Berkshire, SL4 2SE
United Kingdom
Telephone: 0870-225-0109
For all other inquiries:
For New Zealand inquiries:
Monday - Friday 9 am — 5 pm
Monday - Friday 8 am — 4 pm
Parex Industries Ltd.
5 Tolich Place
BISSELL Homecare, Inc.
PO Box 1888
Grand Rapids, MI 49501 USA
Telephone: 01-616-453-4451
Fax: 01-616-453-1383
Henderson 0610
Auckland
New Zealand
Telephone: 0800-247-735
Or visit the BISSELL website - www.bissell.com
When contacting BISSELL, have model number of unit available.
Please record your Model Number: ___________________
Please record your Purchase Date: ___________________
Note: Please keep your original sales receipt. It provides proof of date of purchase in the event of a
warranty claim. See Warranty on page 8 for details.
Please do not return this product to the store.
Replacement parts - BISSELL vacuum
Item
1
Part No.
203-1432
Part Name
HEPA Media Filter Assembly
2
3
1
203-1408
203-1409
2
Flexible Rubber Contour Nozzle
Hard Nozzle
3
7
w w w . b i s s e l l . c o m
ug110-4076_87R4E_1008.indd
7
12/10/08 3:31:19 PM
Warranty - BISSELL Pet Hair Eraser™ Corded Hand Vacuum
This warranty gives you specific legal rights, and you may also have other rights which may vary from country
to country. If you need additional instruction regarding this warranty or have questions regarding what it may
cover, please contact BISSELL Consumer Services by telephone, or regular post as described below, or
contact your local in country distributor.
Limited One Year Warranty
Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, BISSELL Homecare, Inc., will replace (with
new or remanufactured components), at BISSELL’s option, free of charge from the date of purchase by the
original purchaser, for one year any defective or malfunctioning part do to manufacturers defect.
This warranty applies to product used for personal, and not commercial or rental service. This warranty does
not apply to fans or routine maintenance components such as filters, belts, or brushes. Damage or malfunction
caused by negligence, abuse, or use not in accordance with the User’s Guide is not covered.
For UK inquiries:
For Australian inquiries:
Monday - Thursday 9 am — 5 pm
Friday 9 am — 4 pm
Monday - Friday 9 am — 5 pm
BISSELL AUSTRALIA PTY LIMITED
Unit 35
BISSELL Homecare (Overseas) Inc.
The Boat Yard
15 Ricketts Road
Mount Waverley, Victoria 3149
Australia
105 Straight Road
Old Windsor
Telephone: 1-800-811-183
Berkshire, SL4 2SE
United Kingdom
Telephone: 0870-225-0109
For all other inquiries:
For New Zealand inquiries:
Monday - Friday 9 am — 5 pm
Monday - Friday 8 am — 4 pm
Parex Industries Ltd.
5 Tolich Place
BISSELL Homecare, Inc.
PO Box 1888
Grand Rapids, MI 49501 USA
Telephone: 01-616-453-4451
Fax: 01-616-453-1383
Henderson 0610
Auckland
New Zealand
Telephone: 0800-247-735
BISSELL HOMECARE INC. IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES OF ANY NATURE ASSOCIATED WITH THE USE OF THIS PRODUCT.
BISSELL’S LIABILITY WILL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT.
*EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTY
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES
EITHER ORAL OR WRITTEN. ANY IMPLIED WARRANTIES WHICH MAY ARISE
BY OPERATION OF LAW, INCLUDING THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED ©2009 BISSELL Homecare, Inc
Grand Rapids, Michigan
TO THE ONE YEAR DURATION FROM THE DATE OF PURCHASE AS
All rights reserved. Printed in Korea
Part Number 110-4076
Rev 10/08
DESCRIBED ABOVE.
Visit our website at:
w w w . b i s s e l l . c o m
8
ug110-4076_87R4E_1008.indd
8
12/10/08 3:31:19 PM
|