C L E A N I N G / M A I N T E N A N C E
T R O U B L E S H O O T I N G
WA R R A N T Y I N F O R M AT I O N
2. Remove the air inlet grill.
J
3 YEAR LIMITED WARRANTY
TIPS AND TROUBLESHOOTING
Figure 2
C
3. Remove and examine the foam pre-filter. If it has
Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada)
Limited doing business as Jarden Consumer Solutions (collectively “JCS”) warrants that for a period of three years
from the date of purchase, this product will be free from defects in material and workmanship. JCS, at its option, will
repair or replace this product or any component of the product found to be defective during the warranty period.
Replacement will be made with a new or remanufactured product or component. If the product is no longer available,
replacement may be made with a similar product of equal or greater value. This is your exclusive warranty. Do NOT
attempt to repair or adjust any electrical or mechanical functions on this product. Doing so will void this warranty.
This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable.
Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. JCS dealers, service centers,
or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and conditions of this
warranty.
K
collected dust or lint, remove and wash it in warm
soapy water. Rinse and drip dry thoroughly before
placing it back into the grill inlet.
E
Problem
Solution
L
M
•
Unit will not operate
✔ Make sure the unit is plugged in and outlet is energized.
✔ Make sure unit turned ON.
pure indoor living
D
®
4. Check the condition of the PERMAtech filters and
remove if dirty.
•
Decreased air flow
✔ Make sure nothing is blocking air inlet and filtered air outlets.
✔ Remove all plastic bags from filters.
✔ Check condition of filters and clean if necessary.
®
5. Clean the PERMAtech filter.
•
Using your vacuum
Figure 3
cleaner, run the brush
attachment along both
sides of the filter and
clean between the pleated
layers (Figure 3).
B
A
®
•
PERMAtech filter appears ✔ This is normal and does not affect performance in any way. A new filter is not
dirty, even after
vacuuming clean
necessary.
E
This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or
misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair
or alteration by anyone other than JCS or an authorized JCS service center. Further, the warranty does not cover: Acts
of God, such as fire, flood, hurricanes and tornadoes.
F
H
G
•
•
Excessive noise
✔ Remove plastic bags from filters.
IMPORTANT: Do not use
water, household cleaners or
detergents to clean the
I
✔ Make sure parts are firmly positioned in place.
I. Speed Setting
A. Power Button (
B. Speed Controls
)
The filter service indicator ✔ Check condition of the filters and clean if necessary.
will not reset
✔ Press and hold down the Power button ( ) for 3 seconds. The Filter Service
Indicator icon on the display screen should disappear.
®
Indicator (
)
PERMAtech filter.
What are the limits on JCS’s Liability?
JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or
J. Filtered Air Outlet
(not shown)
(
/
)
®
Reinstalling The PERMAtech Filter After Cleaning
C. Timer Button (
D. Ionizer Button (
E. LCD Display
F. Timer Icon/
)
)
statutory warranty or condition.
NOTE: A hang tab and filter
clips ensure the filter attaches
properly.
K. Permanent HEPA-
type filter
Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a
particular purpose is limited in duration to the duration of the above warranty.
L. Washable Foam
Pre-filter
JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise.
JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use
the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of
contract, fundamental or otherwise, or for any claim brought against purchaser by any other party.
Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or
limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights that vary from province to province,
state to state or jurisdiction to jurisdiction.
®
1. Make sure the hang tab
is securely in place. Align
the clip on the top of the
Indicator (
G. Ionizer Icon/
Indicator (
H. Filter Service
Indicator (
)
Air Cleaner Model #
BAP9700
Filter Quantity Needed Filter #
BAPF40-U
Filter Description
PAEIRRMACTLEECHANER
M. Air Inlet Grill
®
2
PERMAtech Filter
)
®
Figure 4
PERMAtech filter with
the rails on the inside of
the unit. Gently slide the
filter onto the rail (see
Figures 4 and 5).
)
WITH REMOTE CONTROL
LEARNING MORE
®
5. If you wish to clean the inside of the air purifier,
For a wealth of information about your air cleaner and other Bionaire products, visit our web site at
please only use a dry, soft cloth to wipe it down. DO
NOT WASH FILTERS.
2. Place air inlet grill back
onto unit securely.
How to Obtain Warranty Service
WARNING: Do not allow moisture to come in contact
In the U.S.A.
3. Reset the Filter
with the main housing of the air purifier.
Service Indicator by
If you have any question regarding this warranty or would like to obtain warranty service, please call
1-800-253-2764 and a convenient service center address will be provided to you.
Figure 5
MODEL: BAP9700
®
pressing the Power button
Cleaning The PERMAtech Filter
(
) for 3 seconds.
®
The PERMAtech filter is designed to never need
In Canada
NOTE: Every time you power on the air cleaner, the
Filter Service Indicator icon ( ) will blink 3 times on
the LCD display. This routine test checks the current
condition of the filters. If filters are in good condition, the
icon will disappear. If not, the icon will remain lit until
filters have been cleaned and Filter Service Indicator
replacement. However, we recommend regular cleaning
If you have any question regarding this warranty or would like to obtain warranty service, please call
1-800-253-2764 and a convenient service center address will be provided to you.
In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions located
in Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing
business as Jarden Consumer Solutions, located at 20 B Hereford Street, Brampton, Ontario L6Y OM1. If you have any
other problem or claim in connection with this product, please write our Consumer Service Department. PLEASE DO
NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE.
for optimal performance.
•
•
Every few weeks, check the condition of the filter.
After approximately 4 months of operation, a Filter
Service Indicator ( ) will appear on the LCD Display
to alert you to clean the filter before further use.
© 2010 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All Rights Reserved. Distributed by
Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431.
Read instructions before operating. Retain for future reference.
(
) has been reset (see instructions above).
To clean the filter:
139782/9100040004481
GCDS-BIO18265-JC
BAP970010EM3
Printed In China
Questions? Comments? Call 1-800-253-2764 in North America
Should the filter become damaged during cleaning,
replacements are available by calling 1-800-253-2764.
1. Turn off and unplug the air cleaner.
BAP9700-U_10EM3.indd 1
6/24/10 10:15 AM
|