Revolution Weather Shield instructions
Fax: (208) 375-5172, BOB Trailers, Inc. 5475 Gage St. Boise, ID 83706
Congratulations on your purchase of the BOB Weather
INSTALLATION INSTRUCTIONS
Shield. It is designed to provide your child protection
from inclement weather. Proper installation and care will
provide years of reliable service.
1. Begin by locating the sun canopy and rear canopy flap
into position to receive the Weather Shield.
Before attempting to assemble or use your new
Weather Shield, read and understand these
instructions completely to insure proper assembly
and operation.
A) Rotate sun canopy
Side
into position as shown
in Fig. 2.
Vents
Front
Vent
If you are unclear on any point, contact your dealer
or BOB before use.
B) Pull canopy draw
string in order to gather
material under canopy.
Sinch cord lock against
canopy to hold material
in place as shown in Fig.
3.
Back
Vents
WARNINGS
This product is designed exclusively for use with
BOB Revolution and Stroller Strides Strollers. It is
not intended for use with other strollers or products.
Fig. 1 Vents unobstructed
Very important: when
the Weather Shield is
used, the rear canopy
flap must be
The Weather Shield is made of a non-breathable
material. To avoid danger of suffocation and
excessive temperatures:
repositioned as
.
described below to
insure proper airflow
and avoid danger of
suffocation.
Follow all assembly instructions.
Rear
Canopy
Flap
.
Make sure all vents are unobstructed, as shown in
Fig.1.
Fig. 2 Canopy positoned
.
C) Fold canopy flap
forward and attach to
Velcro on top of canopy
as shown in Fig. 4.
Note: Instructions on
canopy flap also
The Weather Shield is not designed to work with optional
Infant Car Seat Adapter and car seat.
.
Do not use Weather Shield when temperatures exceed
o
o
65 F/18 C. Use in higher temperatures can cause
unsafe conditions inside the Weather Shield.
Never leave child unattended.
describe this critical
step.
.
.
When not in use, keep out of reach of children.
Canopy
Draw String
D) Inspect opening at
back of stroller (see Fig.
5) to make sure the air
passage space between
top of seat back and
canopy is unobstructed.
We recommend
When the Weather Shield is used, the rear canopy flap
must be repositioned as described below to insure
proper airflow and avoid danger of suffocation.
Fig. 3 Draw String Adjustment
reclining seat back
slightly to optimize
airflow (refer to Reclining
Seat section of stroller
Owner’s Manual).
Fig. 4 Canopy flap forward
2. Position the Weather
Shield on the stroller so
that rear flap drapes
over the back (between
the handlebars) and the
seam above the window
is located over the front
canopy support (see Fig.
6).
Air Passage
Fig. 5 Space between seat
back and canopy unobstructed
3. Stretch the elastic
cord on each side under
OMA05B
P1
|