Yamaha Network Card DSP1D User Manual

Optional Boards  
for  
DSP UNIT  
hank you for choosing the board for Yamaha DSP1D (DSP unit).  
T
の取付けはずヤマハサスエンジニアにご依頼客様ご自身では行なわない。  
Ask an authorized Yamaha service engineer to install the board. Do not install the board yourself.  
の度はヤマDSPユDSP1D買上げいただりがとうごいます。  
The following items are optional boards available for the DSP1D.  
DSP1Dにオプでお求めいただけとおりす。  
INPUT DSP BOARD  
DSPド  
コンソタフェースド  
エンジンマネージド  
パッDSPド  
IDB1D  
CIB1D  
EMB1D  
PDB1D  
GDB1D  
EDB1D  
CONSOLE INTERFACE BOARD  
ENGINE MANAGEMENT BOARD  
PATCH DSP BOARD  
GROUP DSP BOARD  
グループDSPド  
EFFECT DSP BOARD  
エフェDSPド  
Installing the board (For only an authorized Yamaha service engineers)  
ボード装着手順(ヤマハサービスエンジニア用)  
Before installing the board, be sure to turn off the power to the DSP1D and disconnect the power cord.  
You need to remove the front cover of the DSP1D to install any board. To install the PDB1D board, you also need to remove the  
left side cover.  
の装着作業は必ずD S P 1 D の電源チを切抜いてら行なって。  
パッDSPPDB1D外のボの装着はユ面のカバて行ないますPDB1Dの装着ト  
左側面カバーのが必要です。  
1. Remove ten screws as  
shown in the picture. Do  
not remove any other  
screws. Keep the re-  
moved screws in a safe  
place since you will need  
them to re-attach the  
cover.  
2. As shown in the picture,  
remove the cover by  
opening from the right  
side to avoid damage to  
the hardware on the left  
side of the rack.  
10ジをします写  
真にした以外のジはさ  
ないし  
たネジはカバーを再び取り付け  
る際要ですので紛しない  
。  
左側具を破しないよ  
正面カバ右  
ら先に開けてしま  
す。  
左側ラック金具  
hardware on the left side of the rack  
正面カバー  
front cover  
 
<Installing the PDB1D board>  
<P D B 1 D ボードの装着>  
1. Remove the unit front cover as  
described in the previous pro-  
cedure. Remove two ribbon  
cables from the board.  
前述の手順でユ正  
面カバしま  
ル2を  
取りします。  
3. Remove six ribbon cables  
from the board. At this  
time, mark the ribbon  
cables so that you can  
identify each of them and  
re-connect them correctly  
later.  
フラル6本をボから  
取りします。  
この際を再装着  
とき誤接続をため各フ  
ルにマーキング等で  
識別るようにておます。  
フラットケーブル  
ribbon cables  
フラット  
ケーブル  
ribbon  
cable  
2. Remove eight fixing screws  
on the rack mount hardware,  
and remove the rack mount  
hardware. Do not remove any  
screws or hardware other than  
those shown in the picture.  
ラッマウ具の固定  
8ヶ所をし、  
ラッマウを取は  
ずします真にした以  
外ははさ  
側面カバー  
の12ヶのネジを取りず  
側面カバりは  
ずしますマウ金  
具のジと面カバーのネ  
ジは種類が異すの  
でご注さい。  
Remove twelve screws on the  
left side cover, then remove  
it. Note that the screws for the  
rack mount hardware are dif-  
ferent from the screws on the  
side cover.  
下2個  
Two top  
screws  
4. Remove the PDB1D board. At  
this time, care should be taken  
so that the board will not catch  
the ribbon cable.  
PDB引き抜。  
いPDBしま  
の際ーブ  
ルをはし  
さい述の手順の  
逆で面  
カバーマウ具  
正面カバ順に再びり  
付けさい。  
After replacing it with a new  
board, follow the steps de-  
scribed previously to re-install  
the ribbon cables, side cover,  
rack mount hardware, and  
front cover.  
上2個  
Two bottom  
screws  
側面カバー  
side cover  
ラックマウント金具12ヶ  
12 screwsforthe rackm ounthardware  
3
 
ADVARSEL!  
Lithiumbatteri—Eksplosionsfare ved fejlagtig  
håndtering. Udskiftning må kun ske med batteri  
af samme fabrikat og type. Levér det brugte  
batteri tilbage til leverandoren.  
VARNING  
Explosionsfara vid felaktigt batteribyte. Använd  
samma batterityp eller en ekvivalent typ som  
rekommenderas av apparattillverkaren.  
Kassera använt batteri enligt fabrikantens  
instruktion.  
VAROITUS  
Paristo voi räjähtää, jos se on virheellisesti  
asennettu. Vaihda paristo ainoastaan  
laitevalmistajan suosittelemaan tyyppiin. Hävitä  
käytetty paristo valmistajan ohjeiden  
mukaisesti.  
NEDERLAND  
THE NETHERLANDS  
Dit apparaat bevat een lithium batterij voor geheugen  
This apparatus contains a lithium battery for memory  
back-up.  
back-up.  
Raadpleeg uw leverancier over de verwijdering van de  
batterij op het moment dat u het apparaat ann het einde  
van de levensduur afdankt of de volgende Yamaha Service  
Afdeiing:  
For the removal of the battery at the moment of the  
disposal at the end of the service life please consult your  
retailer or Yamaha Service Center as follows:  
Yamaha Music Nederland Service Center  
Address: Kanaalweg 18-G, 3526 KL  
UTRECHT  
Yamaha Music Nederland Service Afdeiing  
Kanaalweg 18-G, 3526 KL UTRECHT  
Tel. 030-2828425  
Tel: 030-2828425  
Gooi de batterij niet weg, maar lever hem in als KCA.  
Do not throw away the battery. Instead, hand it in as small  
chemical waste.  
The above statements apply only to the IDB1D board.  
YAMAHA CORPORATION  
Pro Audio & Digital Musical Instrument Division  
P.O. Box 3, Hamamatsu, 430-8651, Japan  
V510760 R1 1 IP 4  
00 06 300 AP Printed in Japan  
 

Western Digital Computer Drive WD RE3 User Manual
Whirlpool Freezer EV150NXK User Manual
White Rodgers Fan 1D51 User Manual
White Rodgers Switch 770 1 User Manual
Wolf Appliance Company Food Warmer WWD30O User Manual
Xilinx Computer Accessories UG015 User Manual
Zanussi Dishwasher ZDI 6054 QX User Manual
Zanussi Ventilation Hood ZHC 935 User Manual
Zhumell Telephone ECLIPSE 114 User Manual
Zing Magic Camera Accessories 585 802 User Manual