360° USB 2.0 Laptop Stand
with Cooling Fan
user’s guide
brand
model: XB-1002F
Thank you for purchasing an Xbrand 360° 2.0 laptop stand with cooling fan.
Features & how they function
3.
Display height adjustment (Actuator Button): Pressing the Actuator Button allows you to
adjust the position of the Cooling Cradle and thereby your laptop’s display height to any one of
four preset positions.
To change positions perform the following steps:
1. Clasp the corner of your laptop and the bottom of the Cooling Cradle so your laptop and the
Cooling Cradle are firmly grasped between your thumb and fingers.
1.
2. Press down on the Actuator Button (located on unit’s base) with your other hand.
2.
3. Push the Cooling Cradle forwards or backwards approximately 1/2”(1.2 cm) and release
pressure on the Actuator Button.When you hear a“click”, the Cooling Cradle has firmly locked
into one of the four preset positions.
DO NOT REMOVE HAND FROM CRADLE UNTIL YOU HEAR THE
“CLICK”, INDICATING IT HAS LOCKED INTO POSITION.
4. Release your clasp on the Cooling Cradle and your laptop once you are certain the Cooling
Cradle has locked into position.
2.
5. Repeat steps 1-4 to raise or lower system to next preset position.
Front drive access (Folding Retainer): The Folding Retainer located on the bottom of the
Cooling Cradle allows you to gain quick access to drives, bays or buttons located on your
laptop’s front edge.
1.
1. Lower the Cooling Cradle to its lowest position.
2. Push the ‘slide switch’(on front of Cooling Cradle) towards the right and, gently pull the
retainer towards you.When finished, push the retainer back to its original position to lock it
into place. Do not push on the retainer to adjust height of the Cooling Cradle.
ONLY ACCESS FRONT EDGE DRIVES WHEN COOLING CRADLE IS
IN ITS LOWEST POSITION.
360° rotation: Non-skid rollers on the bottom of your unit allow
it to rotate 360° to share your laptop’s display or access rear
connections.
Cooling Fan: Its integrated cooling fan can enhance your
computer’s speed and longevity. 11 blades and a sculpted,
concave design combine to bathe your laptop in cool, ambient
air while supporting proper system ventilation. The on/off switch for the fan is located at the
base of the unit on the left side.
Integrated 4 Port USB 2.0 hub (USB hub equipped models only): A 4-port USB 2.0 Hub is
built into your unit. All 4 ports are located at the rear of the unit. Use these ports to attach USB
powered peripherals: external keyboards, mice, printers, scanners, hard drives, optical drives, etc.
Placement of your 360° 2.0 laptop stand with cooling fan
Proper configuration of your workstation may help relieve back, shoulder and neck strain
that often accompany long hours of working on a laptop computer. For a complete set of
instructions on how to properly set up your workstation, see the US government’s CDC website:
18”–30”(46-76 cm)
LCD screen: Adjust height so the top of your laptop’s display is at or just below eye level when
you are properly seated in an upright position. Move the unit so that your laptop’s LCD screen is
approximately 18”–30”(46–76 cm) from your eyes.
Keyboard & mouse: An external keyboard and mouse are highly recommended when using
this product. Adjust keyboard height so your forearms are parallel to the floor (approx 90° angle
at elbow). Adjust the slope of your keyboard so that the backs of your wrists are flat (in a neutral
position), and not bent back while typing.Your mouse should be at the same height.
|