INSTRUCTIONS
1) Connect the supplied cables from the HDTV HDMI sources into the 3x1 HDMI Switcher inputs.
2) Connect the cables from your display (monitor or projector) into the HDMI out of the 3x1 HDMI
Switcher.
3) Plug the 5VDC power supply into the 3x1 HDMI Switcher.
How to Control the 3x1 HDMI Switcher
Use the RMT3-IR remote control to toggle between sources.
RMT3-IR INSTRUCTIONS
1) Remove battery cover from the back of the RMT3-IR remote.
2) Verify that dip switches 1 & 2 are in the down (OFF) position.
3) Insert the battery, hold the battery so that you can see the positive side facing up. The side that is
not marked must be facing down.
4) Test the RMT3-IR remote by pressing ONLY one button at a time. The indicator light on the remote
will flash once each time you press a button. WARNING: Do not press multiple buttons
simultaneously and do NOT press buttons rapidly. These actions will cause the remote to reset and
steps 1-4 will have to be repeated.
Note: The RMT3-IR ships with two batteries. One battery is required for operation, the second battery
is complimentary.
The optional IR extender allows you to relocate your HDMI Switcher and still have IR control of the
HDMI Switcher
RMT3-IR CODE CONFLICTS
There are matching pairs of dip switches underneath the Switcher unit and under the remote battery
cover. Switch 1 & 2 on the Remote and Switch 1 & 2 underneath the unit are the matching switches.
These switches need to be matched for the remote to communicate with the switcher. There are 4
possible sets of IR codes and at least one of these sets should be able to resolve any IR conflicts with
other home theater devices.
- 3 -
- 4 -
IREXTENDER
1) Plug the IR extender into the Remote port on the front of the Switcher Unit
2) Flip the Dip Switch 1 underneath the unit to the ON position
SPECIFICATIONS
Video Amplifier Bandwidth
Input Video Signal
Input DDC Signal
Single Link Range
Input Connector Type
Output Connector Type
Power Supply
1.65 Gbps
1.2 volts p-p
5 volts p-p (TTL)
1080p / 1920 x 1200
HDMI type A 19 pin female
HDMI type A 19 pin female
5V DC
Power Consumption
Dimensions
Shipping Weight
5 watts (max)
9.375”W x 1”H x 2.75”D
4 lbs.
Technical Support
Mailing Address
Hours:
Phone:
7AM-5PM Pacific
800.843.5465
press 2 for Tech Support
800.492.6832
Xantech Corporation
13100 Telfair Avenue, 2/F
Sylmar, CA 91342
Fax:
email:
HDMI3X1 User Manual © 2007 Xantech Corporation
This document is copyright protected. No part of this manual may be copied or reproduced in any
form without prior written consent from Xantech Corporation.
Document Number 08905127A
- 5 -
|