Instruction Sheet
Model D3277
Gravity Feed Spray Gun
INTRODUCTION
This gravity feed spray gun with a 1.4mm nozzle
includes an in-line regulator for precise control and
a chrome finish for easy clean-up.
Nozzle
Control
Fluid
Control
SETUP
Air Flow
Control
Attach the regulator to the base of the spray gun,
then attach the airline to the regulator with a 1⁄4
NPT fitting. Use the adjustment knob on the
regulator to set the air pressure to 30 PSI.
Pattern
Control
ADJUSTMENTS
See Figure 1 to identify the location of the spray
gun controls and adjust in the following order:
1. Fluid Control—Adjusts the trigger travel, which
affects the volume of paint released.
Figure 1. Model D3277.
2. Air Flow Control—Adjusts the volume of air
that mixes with the paint, and thus, increases
or decreases the paint atomization.
EXPLOSION HAZARD! Do
not spray flammable fluids
near an open flame or
ignition source.
3. Pattern Control—Variably adjusts the spray
pattern from round to a wide fan.
4. Nozzle Control—Adjusts the spray pattern from
vertical to horizontal.
OPERATIONS
Hold the sprayer 6"–8" from the workpiece, and
keep the spray gun perpendicular to the workpiece
during strokes. DO NOT pivot your wrist when
spraying!
EYE
INJURY
AND
HAZARD!
RESPIRATORY
Always use safety glasses
and respirator rated for
paint and solvent vapors
while using sprayer.
MAINTENANCE
1. Clean the spray gun by flushing it with thinner;
however, DO NOT immerse the gun in the
thinner!
2. Regularly clean the filter between the
container and spray gun.
CUSTOMER SERVICE
3. To avoid internal damage, only use the
included brush when cleaning inside the spray
gun orifices.
For questions contact Woodstock International
Technical Support at (360) 734-3482, or send e-
mail to: [email protected].
COPYRIGHT © BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS DOCUMENT MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
SEPTEMBER 2003, PRINTED IN CHINA.
|