FG_ContFeedAttachmentmanual 6/13/06 3:36 PM Page 1
I M P O R T A N T N O T I C E
PLEASE DO NOT RETURN TO STORE.
If you have any problems with this unit,
contact Consumer Relations for service
PHONE: 1-800-275-8273 or
visit our website at wppotsandpans.com
Please read operating instructions
before using this product.
Wolfgang Puck
12-Cup Food Processor
Continuous Flow
Attachment manual
Please keep original box and packing materials
in the event that service is required.
For use with
Wolfgang Puck
12-cup Food Processor
Model WPMFP15
W.P. APPLIANCES, INC. Toll Free (800) 275-8273 Website:
Model WPMFP15AC Printed in China REV 1.0
All trademarks, service marks and trade names (collectively the “Marks”) are proprietary
to Wolfgang Puck World Wide.
FG_ContFeedAttachmentmanual 6/13/06 3:36 PM Page 5
Know Your Continuous Flow
Attachment
Fitting the Continuous
Flow Attachment
(Sold separately)
Processing Bowl with Chute
Before Using the Continuous Flow Attachment
Specially designed to encourage processed
food to be guided into the food collector.
Designed for minimal mess as this chute fits
together with the food collector.
Wash the processing bowl with chute, ejector disc and food collector in
warm water using a mild detergent. dry each part thoroughly before use.
Before you assemble your Food Processor, ensure that the power cord
is unplugged.
1
Place the motor base facing you on a dry,
level surface.
2
Place the processing bowl onto the motor
base, the bowl will only sit correctly on the
base when the handle is positioned to
the right.
Food Collector
Uniquely designed to fit underneath
processing bowl with chute for effortless, no
mess food collection. Holds large quanitities of
food, ensuring continuous processing with
no interruption.
3
Rotate the handle clockwise to lock as
indicated by the graphics on the left side
of the motorbase.
4
5
6
Fit the spindle onto the drive shaft.
Fit the ejector disc over the spindle.
Ejector Disc
Fit the required disc for processing above
the ejector disc on the spindle.
This disc features specially designed ribs to
direct food from the processing bowl to the
food collector.
7
8
Position the lid onto the processing
bowl, ensuring that the lid locks into place,
following lock directions on lid.
Fit the Food Collector underneath the
processing bowl chute. The Food
Collector should fit alongside the food
processor and the opening of bowl should
be in line with the chute. See figure 1 for
the properly assembled unit.
figure 1
3
4
FG_ContFeedAttachmentmanual 6/13/06 3:36 PM Page 7
Recipe Notes
Limited Warranty
This warranty covers all defects in workmanship or materials arising
under normal usage and care, in this product for a period of 12 months
from the date of purchase provided you are able to present a valid
proof-of-purchase. A valid proof-of-purchase is a receipt specifying
item, date purchased, and cost of item. A gift receipt with date of
purchase and item is also an acceptable proof-of-purchase. Product is
intended for household use only. Any commercial use voids the warranty.
This warranty covers the original retail purchaser or gift recipient. During
the applicable warranty period within normal household use,we will
repair or replace, at our discretion, any mechanical or electrical part
which proves defective, or replace unit with a comparable model.
To obtain service under the terms of this warranty,
call Toll Free (800) 275-8273.
THIS LIMITED WARRANTY COVERS UNITS PURCHASED AND USED
WITHIN THE UNITED STATES AND DOES NOT COVER:
•
•
•
Damages from improper installation.
Defects other than manufacturing defects.
Damages from misuse, abuse, accident, alteration, lack of proper
care and maintenance, or incorrect current or voltage.
Damage from service by other than an authorized dealer or
service center.
•
This warranty gives you special legal rights and you may also have other
rights to which you are entitled which may vary from state to state.
5
6
|