Winegard Satellite TV System SF 1000 User Manual

MODEL SF-1000  
Meter with audio tone helps you  
align satellite antenna to  
satellite signal.  
SATELLITE  
FINDER METER  
RECEIVER  
RECEIVER  
SF-1000  
SF-1000  
1. Disconnect the coax from the LNBF and connect it to the  
“To RCVR” jack on the SF-1000.  
2. Plug in receiver and turn power on.  
3. Set receiver to the signal strength screen.  
Note: See your Operators manual for your brand of receiver.  
4. Enter the local zip code in the appropriate area and note the  
azimuth and elevation angles that are displayed.  
5. Adjust the knob on the SF-1000 so the meter indicates  
between 3 and 4.  
6. Connect one end of the supplied jumper coax to the “FROM  
LNBF” jack on the SF-1000 and the other end to the LNBF.  
7. Adjust the antenna to the azimuth and elevation angles that  
were determined in Step 4.  
8. Very slowly adjust the dish up and down and left and right  
until the meter reaches 10 on the scale.  
Meter connects between satellite dish/LNBF  
andsatellitereceiver. WiththeWinegardsatellite  
findermeteryoucaneasilytunethesatellitedish  
to your favorite satellite while outside at the  
antenna without having to run inside to view the  
set-upmenuonthereceiver.  
Specifications  
5-5/8"  
Frequency Range .................. 950-2050 MHz  
Impedance .............................75 ohm  
Input Level .............................-25 to -75 dBm  
Power Required ....................+ 13 - +18 VDC  
(Provided by receiver)  
9. Observe the signal strength meter of the receiver on the TV  
screen to verify that the right satellite has been located.  
10. If the right satellite was NOT located, readjust coarse  
settings.  
11. If the right satellite was located, set the adjustment knob on  
the SF-1000 back to 5 and continue peaking the dish.  
12. As you reach 10 each time you peak the dish, move the  
adjustment knob back to 5 and continue until you can no  
longer improve the signal strength.  
13. Unplug the receiver from its power source.  
14. Without disturbing dish position, disconnect coax from LNBF.  
15. Disconnect coax from the “TO RECEIVER” jack on the  
SF-1000 and connect this coax to the LNBF.  
16. Restore power to the receiver.  
Made In USA  
NOTE: DO NOT adjust the “SENS ADJUST” on the back of the  
SF-1000.  
Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000  
Printed in U.S.A. © Winegard Company 2003  
card size 5-5/8" x 3-5/8"  
3-5/8"  
S:\PACKAGE\RV-6022  
 

Weider Home Gym WEBE08900 User Manual
Whirlpool Clothes Dryer WGD9500TC1 User Manual
Whirlpool Range 9757454 User Manual
Whirlpool Range W10403811C User Manual
Woodstock Saw D3830 User Manual
Xerox Printer 4635 IPS User Manual
Zanussi Microwave Oven ZNM11X User Manual
Zebra Technologies Photo Scanner TTP 2000 User Manual
Zenith Satellite TV System 3235DT User Manual
Zhone Technologies Network Card ADSL2+ Reach High Performance User Manual