Gas Dryer
PRODUCT MODEL NUMBERS
WGD94HEX, WGD95HEX, WGD97HEX
Front view:
Side view:
27"
(686 mm)
381/8"
(968 mm)
* Approx. measurement
3
/4"*
(18 mm)
NOTE: Most installations require a minimum 5" (102 mm)
clearance behind the dryer for the exhaust vent with elbow.
See “Venting Requirements”.
Back view:
61/4"
(159 mm)
Recommended installation clearances (dryer only):
3"
(76 mm)
18" min.
(457 mm)
48 in.2 min.
(310 cm2)
297/8"*
(759 mm)
Water
53/4"*
(146 mm)
31/2"*
(89 mm)
Vent
24 in.2 min.
(155 cm2)
Gas
5"
3"
(76 mm)
(127 mm)
61/8"*
(156 mm)
3/4"*
(18 mm)
143/8"
(365 mm)
253/4"
1"
(25 mm)
1"
(25 mm)
(654 mm)
Installation spacing for recessed area
or closet installation
All dimensions show recommended and minimum spacing allowed.
■
Additional spacing should be considered for ease of
installation and servicing.
■
■
Additional clearances might be required for wall, door, floor moldings, dryer venting, and gas line.
Additional spacing should be considered on all sides
of the dryer to reduce noise transfer.
■
■
For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered
doors with equivalent ventilitation openings are acceptable.
Companion appliance spacing should also be considered.
|