PROFESSIONAL CITRUS JUICER
PCJ SERIES
For your safety and continued enjoyment of this product,
always read the instruction book carefully before using.
the electrical current and the motor will stop; thus saving the
machine from possible damage or fire.
CAUTION: The protector will reset automatically after cooling.
In this case, please turn the unit OFF to ensure that when
the protector resets itself, the citrus juicer will not turn on
unexpectedly.
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS
For your protection, Waring Pro™ Citrus Juicers are equipped
with a 3-conductor cordset that has a molded 3-prong ground-
ing-type plug, and should be used in combination with a prop-
erly connected grounding-type outlet as shown in Figure 1. If
a grounding-type outlet is not available, an adapter, shown in
Figure 2, may be obtained so that a 2-slot wall outlet can be
used with a 3-prong plug. Referring to Figure 3, the adapter
must be grounded by attaching its grounding lug under the
screw of the outlet cover plate. CAUTION: Before using an
adapter, it must be determined that the outlet cover plate
screw is properly grounded. If in doubt, consult a licensed
electrician. Never use an adapter unless you are sure it is
properly grounded.
Note: Use of an adapter is not permitted in Canada.
ASSEMBLY INSTRUCTIONS
•
Choose desired spout position and place bowl so that
it rests flat on top of base.
•
Place reamer-strainer inside of bowl and turn until it rests
into motor drive coupling.
2
PARTS
1.
2.
1. Reamer – strainer
2. Juice bowl with spout
3. Base
3.
4.
4. On/Off Switch
OPERATING INSTRUCTIONS
•
With power cord unplugged, assemble all parts per
assembly instructions.
•
•
Plug power cord into appropriate electrical outlet.
Set switch to ON position and allow a few seconds
for motor to reach full speed.
•
Place halved citrus fruit on rotating reamer, and
push down firmly.
•
Set switch to OFF position when finished juicing.
CAUTION: Keep fingers from contact with rotating
reamer-strainer.
CLEANING INSTRUCTIONS
Clean juicer immediately after each use, and prior
to initial use as follows:
•
•
•
Unplug power cord.
Remove reamer-strainer and bowl from base.
Rinse reamer-strainer and bowl thoroughly under running
water, or place on top rack of dishwasher.
Wipe external surfaces of motor housing with a soft cloth
or sponge, dampened with water.
DO NOT IMMERSE BASE IN WATER.
Allow all parts to air dry, or place on top rack of
dishwasher, and reassemble.
•
•
SPECIFICATIONS
Model
Power Requirements
Power Consumption
PCJ201, PCJ218
120V AC, 60 HZ
1.25 Amps
Waring Consumer Products
150 Milford Road
East Windsor, NJ 08520
Printed in USA
08WR201
026185
3
|