COOKING
Designer Built-In Electric 30”/36”W. Rangetop
Standard Features & Accessories
All models include
• QuickCook™ surface elements utilize
ribbon technology—elements reach
full power in about three seconds
• Strong, wear-resistant glass ceramic
top
continuous heated surface—800 watts
• Right front element—6-1/2” 1,500 watts
• Right rear (dual element)—9” 2,500
watts/6” 1,000 watts
DERT361 model includes
• Left front element—7” 1,800 watts
• Left rear element—7” 1,800 watts
• Bridge element between left front and
left rear elements; creates a
• Right rear (dual element)—8-1/4”
2,200 watts/4-3/4” 750 watts
• High infrared transmission for fast
cooking, regardless of the type of
cookware used
DERT301 model includes
• Left front element—7” 1,800 watts
• Left rear element—7” 1,800 watts
• Bridge element between left front and
left rear elements; creates a
continuous heated surface—800 watts
• Center (dual element)—12” 2,700
watts/8-1/2” 1,700 watts
• Right front element—6-1/2” 1,500 watts
Model Options
DERT301-4B*
30”W. Four-Burner
Rangetop
DERT361-5B*
36”W. Five-Burner
Rangetop
FINISH DETAILS FOR DERT MODELS ONLY
• Stainless Steel/Black (SB)
o Black glass ceramic tops and knob
grips.
• Stainless Steel/White (SW)
o White glass cramic tops with gray
knob grips.
• Brass trim option (BR)—knobs. Brass
components have a durable protective
coating for maintenance-free normal
use.
*Shown throughout with 6”H. backguard. See Installation Notes & Accessories for details.
ORDERING INSTRUCTIONS
First specify model number, and then color code (DERT301-4BSS). If ordering optional brass trim, specify code at end (DERT301-4BSSBR).
PLANNING AND DESIGN GUIDE
RELEASED 12/1/07
©2007 VRC—INFORMATION SUBJECT TO CHANGE
V I K I N G R A N G E . C O M
•
1 - 8 8 8 - V I K I N G 1
COOKING
Designer Built-In Electric 30”/36”W. Rangetop
Dimensions & Specifications
CLEARANCE DIMENSIONS
.
13”max
(33.0 cm)
6”min.
(15.2
18”min.
(45.7 cm)
36”
(91.4
mi
cm)
n.
cm)
A
5-3/4”
(14.6 cm)
)
24-7/16”
.1 cm
(62
36”
(91.4 cm)
A
30”
36“
30” (76.2 cm)
36” (91.4 cm)
Minimum clearances from adjacent
combustible construction*
• Cooking surface and below, i.e., 36”
(91.4 cm) and below
Do not install two or more units
side-by-side.
cm) side clearance must be 18” 45.7
cm) above the 36” (91.4 cm) high
countertop.
4. Wall cabinets above the rangetop
must be a minimum of 36” (91.4 cm)
above the rangetop cooking surface
for the full width of the rangetop. This
minimum height requirement does not
apply if a rangehood is installed over
the cooking surface.
1. This rangetop may be installed directly
adjacent to existing 36” (91.4 cm) high
base cabinets. Important: The top
grate support must be 3/8” (0.95 cm)
above the adjacent base cabinet
countertop.
2. The rangetop cannot be installed
directly adjacent to sidewalls, tall
cabinets, tall appliances, or other side
vertical surfaces above 36” (91.4 cm)
high. There must be a minimum of 6”
(15.2 cm) side clearance from the
rangetop to such combustible surfaces
above the 36” (91.4 cm) counter
height.
o Sides—0”
o Rear—0” with backguard or high-
shelf; 0” with island trim and non-
combustible rear wall; 6” (15.2 cm)
with island trim and combustible rear
wall.
o Top grate support—36” (91.4 cm)
• Above cooking surface, i.e., above 36”
(91.4 cm)
o Sides—6” (15.2 cm)
o Within 6” (15.2 cm) side clearance,
wall cabinets no deeper than 13”
(33.0 cm) must be minimum 18”
(45.7 cm) above cooking surface.
o Wall cabinets directly above product
must be minimum 36” (91.4 cm) for
open top burners above cooking
surface.
3. Within the 6” (15.2 cm) side clearance
to combustible vertical surfaces above
36” (91.4 cm), the maximum wall
cabinet depth must be 13” (33.0 cm)
and wall cabinets within this 6” 15.2
PLANNING AND DESIGN GUIDE
RELEASED 12/1/07
©2007 VRC—INFORMATION SUBJECT TO CHANGE
V I K I N G R A N G E . C O M
•
1 - 8 8 8 - V I K I N G 1
COOKING
Designer Built-In Electric 30”/36”W. Rangetop
Installation Requirements
UTILITY
REQUIREMENTS
ACCESS REQUIREMENTS
GAS
• Not applicable
DERT301-4B
30”W. Four-Burner
Rangetop
DERT361-5B
36”W. Five-Burner
Rangetop
ELECTRICAL
• Electrical
connection—40
amp. Three-wire,
240/208V, 60Hz. Unit
is equipped with No.
10 ground wire in
conduit. Should be
fused separately.
• Check your national
and local codes
regarding this unit.
• Four-foot (121.9 cm)
cord included with
range; three-wire
with ground/three-
prong plug
24-7/16”
(62.1 cm)
• Maximum amp
usage—
3/4”
(1.9 cm) min
o DERT 30"
.
o 240V—35.0
o 208V—30.3
o DERT 36”
o 240V—45.0
o 208V—40.0
PLUMBING
Not applicable
DERT301-4B
30” (76.2 cm)
5-3/4” (14.6 cm)
DERT361-5B
36” (91.4 cm)
5-3/4” (14.6 cm
Cutout width
Cutout height
Cutout depth
Surface element rating
Left front
24-7/16” (62.1 cm)
240V 208V
240V
208V
240V
208V
1,800 watts 1,350 watts
1,800 watts 1,350 watts
Bridge
800 watts 600 watts
Left rear
Center (dual element)
1,800 watts 1,350 watts
N/A
1,800 watts 1,350 watts
2,700/
2,025 watts
1,700 watts
Right front
1,500 watts 1,125 watts
1,500 watts 1,125 watts
Right rear (dual element)
2,500/
1,875 watts
2,200/
1,650 watts
1,000 watts
750 watts
PLANNING AND DESIGN GUIDE
RELEASED 12/1/07
©2007 VRC—INFORMATION SUBJECT TO CHANGE
V I K I N G R A N G E . C O M
•
1 - 8 8 8 - V I K I N G 1
COOKING
Designer Built-In Electric 30”/36”W. Rangetop
Installation Notes & Accessories
✪
A backguard, high-shelf, or island trim must be used for all installations.
6”H. Backguard
• Stainless Steel (SS)
• Coordinates with all finishes
Model
D30BG6
D36BG6
Description
30”W. backguard
Approx. ship wt. lbs. (kg)
14 (6.3)
36”W. backguard
14 (6.3)
10”H. Backguard
• Stainless Steel (SS)
• Coordinates with all finishes
Model
Description
Approx. ship wt. lbs. (kg)
D36BG10
36”W. backguard
17 (7.7)
High-shelf
• Stainless Steel (SS)
• Coordinates with all finishes
• Shelf comes attached to a 24”H. backguard
Model
Description
Approx. ship wt. lbs. (kg)
D30HS24
30”W. high-shelf
45 (20.3)
D36HS24
36”W. high-shelf
50 (22.5)
Island Trim
• Stainless Steel (SS)
• Coordinates with all finishes
• For island/peninsula installation
• Can replace backguard if wall is non-combustible
Model
D30TII
D36TII
Description
30”W. island trim
Approx. ship wt. lbs. (kg)
10 (4.5)
36”W. island trim
11 (5.0)
Countertop Side Trim
• Stainless Steel (SS)
• Coordinates with all finishes
• Installs on side of unit; overlaps countertop
• One pair of trim
Model
Description
Approx. ship wt. lbs. (kg)
TE24CST
Side trim
2 (0.9)
Compliance Information
WARRANTY INFORMATION*
• One-year full warranty—complete product
• Ten-year limited warranty—all electric elements/oven elements
• Ninety-day limited warranty—cosmetic parts such as glass, painted, and decorative items
* For complete warranty see Use & Care Guide. Warranty valid on Viking products shipped within the United States and Canada.
PLANNING AND DESIGN GUIDE
RELEASED 12/1/07
©2007 VRC—INFORMATION SUBJECT TO CHANGE
V I K I N G R A N G E . C O M
•
1 - 8 8 8 - V I K I N G 1
|