Video Products Computer Hardware USB SUN User Manual

NETWORK  
TECHNOLOGIES  
INCORPORATED  
1275 Danner Dr  
Aurora, OH 44202  
Tel:330-562-7070  
Fax:330-562-1999  
NTI  
USB-SUN USB TO SUN ADAPTER  
INSTALLATION / USER GUIDE  
M A N 0 1 5 R E V 1 1 / 2 3 / 0 1  
 
Setup  
When using the USB-SUN adapter to connect to an NTI KVM switch:  
1. Connect one male 8 pin minDIN end of the SKTINT-xx-MM cable to a female 8 pin minDIN Keyboard and Mouse input port on the  
NTI KVM switch being used (see Fig. 3). Switch the power ON to the KVM switch if it isn't already.  
2. Connect the other male 8 pin miniDIN end of the SKTINT-xx-MM cable to the 8 pin miniDIN female port on the USB-SUN  
adapter.  
Mating Face of a 8 Pin miniDIN Female  
Fig. 3  
3. Connect the USB type B male connector of the USB-AB-0.5M-5T cable (see Fig. 4) to the USB type B female port on the USB-  
SUN adapter.  
4. Connect the USB type A male connector of the USB-AB-0.5M-5T cable (see Fig. 5) to a USB type A female port on the host  
computer. Note: It is important to make this connection last, particularly if the host computer is already ON at the time of  
connection.  
USB Type A Male  
USB Type B Male  
Connector  
Connector  
Fig. 5  
Fig. 4  
When using the USB-SUN adapter to connect a SUN Keyboard and/or Mouse to a SUN CPU with a USB port:  
1. Connect the 8 pin minDIN male connector of the SUN keyboard and mouse assembly into the female 8 pin miniDIN port  
on the USB-SUN adapter.  
2. Continue with steps 3 and 4 above.  
2
 
PLEASE NOTE: It is necessary to configure the host (Sun) computer such that the Sleep Mode is not enabled. If the host computer  
goes into sleep mode either automatically or manually, the user must reboot the host computer in order to resume use of the host  
computer.  
To disable the Sleep Mode, perform the following steps:  
1.  
2.  
3.  
4.  
5.  
Select "Power Manager"  
Look for "Device Idle Time Before Power Saving Starts"  
Select "Always ON"  
Look for "Override Device Idle Time For:"  
Make sure neither "Monitors " nor "Disks" are selected.  
Technical Specifications  
M a t i n g F a c e o f a 8 p i n m i n i D I N F e m a l e  
Mating face of a USB Type B Female  
2
1
4
8
6
7
4
5
3
3
2
1
Fig. 6  
Fig. 7  
PIN #  
SIGNAL  
+VCC  
PIN #  
SIGNAL  
GND  
1
2
3
4
1
2
3
4
5
6
7
8
- DATA  
+DATA  
GND  
GND  
+5  
MOUSE  
KYBD RCV  
KYBD XMT  
PWRN  
+5  
WARRANTY INFORMATION  
The warranty period on this product (parts and labor) is one (1) year from the date of manufacture (indicated on the bottom of the  
product). Please contact Network Technologies Inc at (800) 742-8324 (800-RGB-TECH) or (330) 562-7070 or visit our website at  
http://www.nti1.com for information regarding repairs and/or returns. A return authorization number is required for all repairs/returns.  
C O P Y R I G H T  
Copyright © 2001 by Network Technologies Inc. All rights reserved. No part of this publication may be reproduced, stored in a  
retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without  
the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202  
C H A N G E S  
The material in this guide is for information only and is subject to change without notice. Network Technologies Inc reserves the right  
to make changes in the product design without reservation and without notification to its users.  
SERIAL NO.:  
INSPECTED BY:  
DATE:  
3
 

Telex Stereo Amplifier 801 35A User Manual
Timex Watch W 179 US User Manual
TP Link Modem TD W8960N User Manual
Turbosound Speaker B 12DP User Manual
Tyco Computer Monitor 1847L Series User Manual
Ultra electronic Printer Rio 2E User Manual
Uniden Cordless Telephone WDECT3355 WDECT3355 User Manual
Uniden Cordless Telephone XC3510 User Manual
Uniflame Outdoor Fireplace WAD931SP User Manual
United States Stove Furnace HOTBLAST 1950 User Manual