Vermont Casting Indoor Fireplace DV36 39 User Manual

DV36/39 STKP and  
CBTK  
Use the  
outermost  
hole  
Top Hanger  
Brackets  
Bay Front Kits  
Installation Instructions  
Please read these instructions before beginning  
assembly.  
KT232  
Fig. 1 Be sure that each of the steel brackets is securely at-  
tached to the fireplace frame.  
Caution  
Porcelain enamel is fragile. The finish can be eas-  
ily damaged if castings are not handled carefully.  
Always place castings on a protective surface, such  
as a towel, blanket or carpet.  
4. Hang the window panel on the firebox front by en-  
gaging its upper rail over the back of the top of the  
firebox opening frame. (Fig. 2)  
Remove the protective film from the brass trim  
sections, if applicable.  
Carefully unpack the Front Face components and in-  
spect for damage. Report missing or damaged parts to  
your dealer immediately.  
Upper Rail  
Kit Contents  
Upper Grille Assy.  
Window Assy.  
Hanger Brackets, 2  
Knob Ext., Philostat  
Base Grille Assy.  
Base Trim Piece  
Knob Ext., Hi/Lo  
Knob Ext., Piezo  
Ceramic  
Refractory  
Ceramic  
Refractory  
Knob, Off/On Ext. SIT#916.188  
Knob, HI/LO Ext., SIT#916.189  
#10 x 1/2” sheet metal screws, 2  
Ceramic Refractory, 2  
You will need a Phillips screwdriver to install the front.  
The fireplace installation should be complete and in-  
spected. Any surround and trim assemblies should also  
be installed before setting the front face in position.  
KT233  
Fig. 2 Cast window panel shown, Steel window mounts in the  
same manner.  
Installation  
5. The base trim piece is used to close a gap that might  
exist between the base grille and a lower hearth.  
Attach the trim section to the base grille by engaging  
the narrow flange to the clips on the underside of the  
base grille. (Fig. 3)  
1. Remove the upper louvre section from the DV fire-  
box front.  
2. Fasten the two top brackets at the existing holes in  
the upper inside lip of the firebox. Use the left hole  
on the left bracket and the right hole on the right  
bracket. (Fig. 1)  
3. Place two (2) ceramic refractory pieces into window  
assembly. (Fig. 2) CAUTION: The ceramic refractory  
pieces are very fragile, handle with care!  
30000429 8/08 Rev. 4  
 

Thule Automobile Accessories 881 Top Deck User Manual
Toshiba VCR kV 9960A User Manual
TP Link Network Router TX 6610 User Manual
Ultra electronic Printer Latin Series User Manual
Uniden Cordless Telephone EXI5160 User Manual
Uniden Scanner UBC144XLT User Manual
Uniden Speaker HS 120B User Manual
Varimixer Meat Grinder 305 User Manual
Vision Fitness Treadmill TM357 User Manual
Vox DJ Equipment AC15H1TV User Manual