Setup Instructions - JS-XS300
Set up your keyboard on a sturdy, lightweight stand, with the JS-XS300 keyboard stand. Easily adjustable to sitting or standing heights
thanks to the large tightening knob, the X-style keyboard stand accommodates a variety of playing situations. The JS-XS300 folds flat
for easy transport and storage.
SETUP INSTRUCTIONS — JS-XS300
:
PARTS INCLUDED
STEP 1.
Stand top
Knob
( )
A. 2 Bottom Support Arms
A.
( )
B. 1 Cross-bar
B.
( )
C. 1 Allen Wrench,
Attached to Cross-bar
Belt
( )
D. 2 Top Support Arms
D.
C.
( )
E. 4 Screws
E.
Stand bottom
1. Open the cross-bars until they snap into a stable position. See picture
for upright position reference.
STEP 2.
STEP 3.
Shorter end
Shorter end
Shorter end
Shorter end
Belt
Knob
Knob
Belt
2. Using the provided Allen wrench and screws, attach the long
supports legs to the bottom of the stand. The shorter end of
each support leg should be facing away from the attaching
cross-bar center joint (see picture).
3. Attach the shorter support arms to the top of the stand. Again,
the shorter end of the support arm should be facing out away
from the attaching cross-bar center joint (see picture).
STEP 4.
4. To adjust stand height, pull the spring-loaded knob until the pin
clears the adjustment plate. Adjust legs until stand is at desired
height, then release knob so that the pin snaps into place in one
of the holes on the adjustment plate. Do not turn the knob - this
can result in the loss of the spring.
R. 1, 08/31/10, JAM-HT_JS-XS300
Web. www.ultimatesupport.com
5836 Wright Drive
Loveland, CO 80538
Phone. 1-800-525-5628
Fax. 970.776.1941
•
•
•
•
|