TM-ST2
XY Stereo Microphone
Description
Installing the battery
TASCAM’s TM-ST2 is a stereo microphone designed for
studio and live recording. is X/Y microphone cap-
tures a wide stereo image with rich sound quality. e
unbalanced output is perfect for connecting to TASCAM
portable recorders like the DR1 and GT-R1. A low cut
filter is available to remove low frequency rumble during
recording. e TM-ST2 includes a 10’ cable as well as an
18” cable for shorter runs or video camera connection.
Also included are a microphone stand clip, wind screen,
AA battery and protective carry pouch.
1.
2.
Unscrew microphone body cover
Remove the body shell to expose the battery
holder
3.
Insert the battery, taking note of the polarity
markings
Battery Precautions:
•
•
•
Insert the battery correctly
Do not charge the included AA battery
Remove the battery if the microphone will not
be used for a long period of time
Simple to operate, the TM-ST2 is a surprisingly afford-
able solution to recording great-sounding stereo tracks.
•
If the battery leaks, clean the battery holder
before inserting a new battery
Specifications
Power Switch
Model:
Elements:
Type:
TM-ST2
To operate the microphone, move the power switch
to the ON position. An alkaline AA battery provides
approximately 400 hours of operation under normal
circumstances.
Back Electret Condenser
X/Y Stereo
Frequency Response: 30 Hz - 20kHz
Sensitivity @ 1Pa:
Impedance:
Maximum SPL:
Dynamic Range:
Power:
Consumption:
Connector:
Weight:
-47 dBV
200Ω, UNBALANCED
126 dB SPL
Using the Low Cut Filter
e low-cut filter switch is located on the inside of the
microphone. e switch is off (flat) by default. To switch
on the low cut filter:
102 dB
AA Battery
2 mA
Integral 3-pin XLR-M
320g/11.3 oz.
1.
2.
3.
Unscrew microphone body cover.
Slide the body shell down as far as it will go.
On the bottom of the microphone, near the out
put jack, you will find the small low cut switch.
Move the switch to the leſt to engage the rolloff
4.
(indicated by the
icon). Move the switch
to the right for full bass response (indicated by
the icon).
e low cut filter attenuates frequencies below 150Hz at
a cutoff slope of 6dB per octave.
Included Accessories:
•
•
•
•
•
•
10’ Stereo (XLR-F to Stereo 3.5mm M) cable
18” Stereo (XLR-F to Stereo 3.5mm M) cable
Microphone Stand Clip
AA Battery
Windscreen
Protective Pouch
|