Targus Mouse 410 0008 001A User Manual

wireless  
laser  
rechargeable  
notebook mouse  
USER GUIDE  
Visit our Website at www.targus.com  
Features and speciꢀcations are subject to change  
without notice.  
©2006 Targus Group International, Inc. and Targus, Inc.  
AMW15US / 410-0008-001A  
 
Table of Contents  
Introduction ..........................................3  
Package Contents ................................3  
System Requirements ..........................4  
Connecting the Mouse Receiver ..........4  
Installing the Batteries ..........................4  
Charging the Batteries .........................6  
Synchronization ....................................7  
Mouse Power Management .................8  
Safety Measures ..................................8  
Operating Hints ....................................8  
Troubleshooting ...................................9  
Technical Support ..............................11  
Product Registration ...........................11  
Warranty .............................................11  
Regulatory Compliance ......................12  
 
2
TARGUS WIRELESS  
LASER  
RECHARGEABLE  
NOTEBOOK MOUSE  
Introduction  
Congratulations on your purchase of a Targus Wireless  
Laser Rechargeable Notebook Mouse. This compact  
mini mouse incorporates new laser tracking technology,  
offering 20 times more sensitivity than a traditional LED  
optical mouse. The images the laser receives are more  
detailed, with higher contrast. The mouse can track more  
reliably, even on reflective surfaces, and its small footprint  
makes it ideal for portable computing.  
NOTE: WHILE THE MOUSE IS FUNCTIONING, NO LASER LIGHT IS VISIBLE TO THE  
NAKED EYE. BE CAREFUL NOT TO LOOK DIRECTLY INTO THE EMITTER HOLE  
WHILE THE MOUSE IS ACTIVE.  
Package Contents  
Wireless Laser Mouse  
USB charge cable  
USB receiver  
USB extension cable  
2 AAA rechargeable batteries Carrying pouch  
 
3
Targus Wireless Laser Rechargeable Notebook Mouse  
System Requirements  
Hardware  
• USB port  
Operating System  
• Windows® 98SE/ME/2000/XP or Mac OS X and above  
Connecting  
Receiver  
the  
Mouse  
To connect the mouse receiver:  
1
2
Plug the USB receiver into an available USB port on  
your computer.  
Your computer’s operating system identifies the  
receiver and begins installing the default driver.  
If applicable, follow any on-screen procedures to  
complete the native driver installation.  
Installing the Batteries  
1
If the mouse is on, slide the on/off switch on the  
bottom of the mouse to the “off” position.  
 
4
Targus Wireless Laser Rechargeable Notebook Mouse  
2
Remove the battery cover from the top of the mouse  
by pressing the battery cover hinge located on the  
bottom of the mouse and sliding it off.  
On/Off switch  
Connect  
button  
Laser  
Battery cover  
hinge  
Mouse Bottom  
NOTE: THE BATTERY COVER IS ALSO THE TOP COVER OF THE MOUSE.  
 
5
Targus Wireless Laser Rechargeable Notebook Mouse  
3
Insert the supplied batteries, making sure that the  
positive (+) and negative (-) ends of each battery  
match the polarity indicators inside the battery  
housing.  
WARNING: WHEN REPLACING THE BATTERIES, USE ONLY HEAVY-DUTY NIMH  
RECHARGEABLE BATTERIES. NEVER USE ALKALINE BATTERIES.  
AVOID MIXING NEW AND USED BATTERIES IN A DEVICE.  
4
5
Slide the battery cover back into position until it  
“clicks” firmly into place.  
Turn on the mouse by sliding the on/off switch on the  
bottom of the mouse to the “on” position.  
NOTE: WHILE THE MOUSE IS FUNCTIONING, NO LASER LIGHT IS VISIBLE TO THE  
NAKED EYE. BE CAREFUL NOT TO LOOK DIRECTLY INTO THE EMITTER HOLE  
WHILE THE MOUSE IS ACTIVE.  
Charging the Batteries  
For best results, you should charge the mouse at least 4  
hours before using it. You can do this via the supplied  
USB charge cable. To do this:  
1
Connect the cable’s USB connector into an available  
USB port on your computer.  
2
Connect the other end to the mouse.  
NOTE: TO CONTINUOUSLY CHARGE THE MOUSE VIA THE USB CHARGE CABLE,  
YOUR COMPUTER MUST BE ON AND AWAKE. FOR BEST RESULTS, TURN OFF  
YOUR COMPUTERS POWER MANAGEMENT FEATURE WHILE CHARGING THE  
MOUSE.  
 
6
Targus Wireless Laser Rechargeable Notebook Mouse  
Synchronization  
After your computer detects the USB receiver you must  
establish a communications link between the mouse and  
its receiver BEFORE you can use the mouse. To do this,  
follow the instructions below:  
1
Press and release the connect button located at the  
bottom of the receiver.  
Connect button  
Receiver  
The receiver’s status light blinks when the receiver is  
activated.  
2
Press and release the connect button, located on the  
bottom of the mouse.  
You are now ready to use the mouse.  
NOTE: DUE TO THE IMPROVED TRACKING SPEED OF THE LASER ENGINE, USERS  
MAY FIND THE CURSOR MOVEMENT IS FASTER THAN A CONVENTIONAL OPTICAL  
MOUSE. CURSOR SETTINGS CAN BE CHANGED FROM YOUR COMPUTERS  
CONTROL PANEL.  
 
7
 
Targus Wireless Laser Rechargeable Notebook Mouse  
Mouse Power Management  
To power the mouse on and off, slide the on/off switch  
at the bottom of the mouse to the desired position.  
• When power is on, the mouse goes into "sleep mode"  
after 8 minutes of non-use. To activate the mouse,  
press any mouse button.  
Safety Measures  
• Although this mouse is a Class 1 Laser Product and  
safe for operation, avoid pointing the laser into the eyes  
or looking directly into the laser emitter.  
• Keep the mouse away from young children.  
• Any attempt to disassemble, adjust or repair the mouse  
may result in exposure to laser light or other safety  
hazards.  
Operating Hints  
For optimal performance and RF reception:  
• Place the receiver at least 8 inches (20 cm) away from  
all electrical devices, such as your monitor, speakers or  
external storage devices.  
If necessary, use the supplied extension cable to keep  
the receiver away from the computer. Plug the  
receiver into the extension cable, and the extension  
cable to the computer.  
 
8
Targus Wireless Laser Rechargeable Notebook Mouse  
• Avoid using the mouse on a metal surface. Metals,  
such as iron, aluminum or copper, shield the radio  
frequency transmission and may slow down the  
mouse’s response time or cause the mouse to fail  
temporarily.  
• The mouse will enter a suspend mode at the same time  
your computer does. To activate the mouse press any  
mouse button.  
• If your computer has a metal case that contains  
aluminum or magnesium, use the mouse to the side.  
The display panel may interfere with the radio  
frequency signal if you use the mouse directly in front  
of the computer.  
Troubleshooting  
What do I do if the mouse does not work?  
• Make sure that the polarity of the batteries is correct.  
The positive (+) and negative (-) ends of each battery  
must match the positive (+) and negative (-)  
connections in the battery housing.  
• Make sure that the batteries are fully charged. Check  
your computer’s suspend mode settings, as the mouse  
will not charge while the computer is in suspend mode.  
• Check that the receiver's USB connector is firmly  
attached to the USB port on your computer.  
• Make sure you have established  
a
wireless link  
between the mouse and its receiver. See  
 
9
Targus Wireless Laser Rechargeable Notebook Mouse  
I do not see the laser light when the mouse is  
active.  
• Unlike traditional optical mice, the light is not visible  
when the laser mouse is active.  
To make sure the mouse is on and functioning properly,  
move the mouse back and forth and check to see if the  
cursor responds.  
My mouse does not work on a mirror or glass  
surface.  
• Though rated for most of these kinds of surfaces,  
occasionally there will be one such surface that will  
cause the mouse to work improperly or not at all.  
• If you are using the mouse on a reflective or mirrored  
surface, move it to another surface.  
What do I do if the response time of the mouse  
is slow or the mouse intermittently stops  
working?  
• Metals, such as iron, aluminum or copper may slow  
down the mouse's response time or cause the mouse  
to fail temporarily.  
• If you are using the mouse on a metal surface, move it  
and the receiver to a non-metal surface.  
 
10  
Targus Wireless Laser Rechargeable Notebook Mouse  
Technical Support  
For technical questions, please visit:  
US  
Internet:  
Australia  
Internet:  
Email:  
Telephone: 1800-641-645  
New Zealand  
Telephone: 0800-633-222  
Product Registration  
Targus recommends that you register your Targus accessory  
shortly after purchasing it. To register your Targus accessory, go  
You will need to provide your full name, email address, phone  
number, and company information (if applicable).  
Warranty  
Targus warrants this product to be free from defects in materials  
and workmanship for one year. If your Targus accessory is found  
to be defective within that time, we will promptly repair or replace  
it. This warranty does not cover accidental damage, wear and  
tear, or consequential or incidental loss. Under no conditions is  
Targus liable for loss of, or damage to a computer; nor loss of, or  
damage to, programs, records, or data; nor any consequential or  
incidental damages, even if Targus has been informed of their  
possibility. This warranty does not affect your statutory rights.  
 
11  
Targus Wireless Laser Rechargeable Notebook Mouse  
Regulatory Compliance  
This device complies with Part 15 of the FCC Rules. Operation is  
subject to the following two conditions: (1) This device may not  
cause harmful interference, and (2) This device must accept any  
interference received, including interference that may cause  
undesired operation.  
FCC Statement  
Tested to Comply  
This equipment has been tested and found to comply with the  
limits of a Class B digital device, pursuant to Part 15 of the FCC  
Rules. These limits are designed to provide reasonable protection  
against harmful interference in a residential installation. This  
equipment generates, uses, and can radiate radio frequency  
energy and if not installed and used in accordance with the  
instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that interference  
will not occur in a particular installation.  
If this equipment does cause harmful interference to radio or  
television reception, which can be determined by turning the  
equipment off and on, the user is encouraged to try to correct the  
interference by one or more of the following measures:  
Reorient or relocate the receiving antenna;  
Increase the separation between the equipment and receiver;  
Connect the equipment into an outlet on a circuit different from  
that to which the receiver is connected;  
Consult the dealer or experienced radio/TV technician for help.  
Windows is  
a
registered trademark of Microsoft Corporation. All trademarks and  
registered trademarks are the property of their respective owners. Features and  
specifications subject to change without notice. © 2006, Targus Group International, Inc.  
and Targus, Inc., Anaheim, CA 92806 USA.  
 
12  

Sharp Air Cleaner FZ C150DFU User Manual
Sharp Computer Monitor LL T15A4 User Manual
Singer Sewing Machine 99W86 User Manual
Sonic Alert Clock SBP100 User Manual
Sony Microphone ECM S930C User Manual
Speco Technologies Security Camera CVC 627B User Manual
SpectronIQ Home Theater System PHT 300X User Manual
Spirit Waterskis xt9 User Manual
Stiga Lawn Mower 107 M EL User Manual
SUPER MICRO Computer Computer Hardware H8SCM User Manual