TM
Setting up TS 100 Phones with TalkSwitch
Quick Guide
Factory Presets
The following table shows you the factory settings for your unit:
Display
Setting
Language
English
LCD Contrast
Area Code
LDS Code
3
no setting
1
Flash
Access Code
- (no Hunt Group Selected)
Initial Setup
After the adapter is connected, the display will show as indicated below for setting.
1. [SET LANGUAGE] appears on the display. Press the REVIEW UP ( ) button to select
the language. E - English, F - French, S - Spanish, and then press the DIAL button to
confirm the selection.
E
SET LANGUAGE
2. When [LCD CONTRAST] appears, press the REVIEW UP ( ) button to set the contrast
darker, and then you can press the REVIEW DOWN ( ) button to set the contrast back
to the preset.
2
LCD CONTRAST
3. When [SET AREA CODE] appears, use the REVIEW UP ( ) BUTTON and the REVIEW
DOWN ( ) button to set your local area code:
- - -
SET AREA CODE
REVIEW UP ( ) button - to change the digit from -, 0 to 9.
REVIEW DOWN ( ) button - to move to the next digit.
When you are finished setting the local area code, press Dial.
4. When [SET LDS CODE] appears, press the REVIEW UP ( ) button to change the long
distance code from -, 0, 1, 2, -9.
1
SET LDS CODE
When you are finished, Press DIAL. The display will indicate as shown (Stand-by Screen)
and be ready to receive incoming calls. You have to set the LDS code as 1 when you
are in the USA or Canada.
5. When [SET ACCESS CODE] appears, use the REVIEW UP ( ) button and the REVIEW
DOWN ( ) button to set your access code. The Code can range from _ to 9. The
Access Code is used to obtain an outside line when using TalkSwitch (without ‘Direct Line
Access’ enabled) and some Centrex applications. This feature can be used with Caller ID
and Memory Locations. If you do not have ‘Direct Line Access’ enabled, then set this
code to ‘9’.
What is Direct Line Access? Direct Line Access allows you to make external calls
without having to dial ‘9’ first. Note: To access some of the TalkSwitch features with Direct
hold / flash
Line Access enabled, you must press the
button first. See the Using TS 100
Phones with TalkSwitch Quick Guide for more details.
6. The time and date are automatically set when a caller ID (CID) number is received. The
unit will keep the current time accurately, and is updated each time a CID number is
received.
Reprogramming
After you have set up the unit completely for the first time, you can use the MENU button to
review or reprogram the Language, Contrast, Area Code, LDS Code or Access Code. Use the
REVIEW UP ( ) and REVIEW DOWN (
to scroll through the settings.
) buttons to set the options and the DIAL button
copyright Centrepoint Technologies Inc. 2005 document #: CT.TS005.5xx.EN - 01 (June 2005)
|