3G Gateway Installation
1
2
3
LAN4
LAN4
LAN3
LAN3
LAN2
LAN2
LAN1
LAN1
L A N 1
L A N 2
L A N 3
L A N 4
Connect the Ethernet LAN cable to socket LAN 1.
Connect the null modem cable between the Data
socket and a PC.
Mount the rack ears and/or rubber feet, if
applicable, and turn the unit back on its feet
or mount it in the rack.
Unpack the 3G Gateway.
4a
4b
4c
I
I
I
o
o
o
Depending on version, connect the PRI connector …
or...
connect the 4 PRI connectors …
or...
… connect the 4 BRI connectors.
1. Start a Terminal program on the PC and configure it to
115ꢀ200,ꢀ8,ꢀ1,ꢀNone
I
2. When prompted for login, enter username admin and
password TANDBERG.
5
6
o
3. Type y to start the installation wizard and press Enter.
4. When prompted, specify a new password, IP settings, lo-
I
o
cal prefix, SSH y/n, and Telnet y/n.
5. When prompted for login, enter username admin and your
new password.
6. Press Enter to skip the installation wizard.
7. Reboot the system by typing the command xcommand
boot
Connect the power cable and turn on the 3G
Gateway. Use the LCD display of the unit to set
the IP address – see Configuring the 3G Gateway
in the User Manual for details, or...
Start a Terminal program on the PC
and configure it to 115ꢀ200,ꢀ8,ꢀ1,ꢀNone
8. Do the rest of the configuration from the web interface.
115196 rev. 02
|