TM
INSTRUCTIONS
Contents:
1 SkyWinder™ Stunt Plane
1 Controller
TM
1 Charger/Trainer/Display Stand
2 Extra Propellers
1 Tool
ON/OFF
Switch
Charging
Indicator
Light
NO ASSEMBLY
REQUIRED
Toggle
Vertical
Tail Wing
Thrust
Button
Tool
Rudder
Land
Button
Stunt Flap
CONTROLLER
Antenna
Stunt Flap
Adjustment
Knob
Horizontal
Tail
ON/OFF
Switch
Charging
Light
Charging
Hose
Wing
Ready
Light
Main
Wing
Plane
Body
Propeller
Charge
Nozzle
Propeller
Tip
Training
Stand
Charging
Port
Charger
Base
ON/OFF
Switch
Propeller
Propeller
Tip
SKYWINDER™ STUNT PLANE
CHARGER/TRAINER/DISPLAY STAND
BATTERY INSTALLATION
CONTROLLER
CHARGER/TRAINER/
DISPLAY STAND
1. Use a Phillips screwdriver
to loosen the screw in the
battery compartment door.
2. Remove the battery door.
3. Insert six 1.5 Volt AA
batteries (not included).
4. Replace battery
1. Use a Phillips screwdriver
to loosen the screw in the
battery compartment door.
2. Remove the battery door.
3. Insert eight 1.5 Volt D
alkaline batteries
(not included).
compartment door and
refasten the screw.
4. Replace battery
compartment door and
refasten the screw.
IMPORTANT:
Be sure to insert the
batteries as indicated
inside compartment with
the correct polarity.
IMPORTANT:
Be sure to insert the
batteries as indicated inside
compartment with the
correct polarity.
IMPORTANT BATTERY INFORMATION
• Battery installation should be performed by an adult.
• Use only batteries recommended. Be careful to install the batteries with the
correct polarity, as indicated.
• CAUTION: Plane contains a rechargeable cell. If fluid leaks from the plane,
avoid contact with eyes and dispose of the plane. Only use charger supplied
with this package.
• Do NOT use any other source to charge your SkyWinderTM.
• Different types of batteries or new and used batteries are not to be mixed.
• Do not use rechargeable batteries.
• Do NOT mix old and new batteries.
• Do NOT mix alkaline, standard, or rechargeable batteries.
• Do NOT attempt to charge non-rechargeable batteries.
• Do NOT short circuit the supply terminals.
• Only batteries of the same or equivalent type as recommended are to be used.
• Rechargeable batteries are to be removed from the toy before being
charged (if removable).
• Rechargeable batteries are only to be charged under adult supervision
(if removable).
• Do NOT overcharge the plane’s batteries.
• Exhausted batteries are to be removed, as they will adversely affect the
performance.
• Do not dispose of batteries in fire. Battery may explode or leak.
SETTING UP YOUR SKYWINDERTM FOR INDOOR TRAINING continued
STEP 4
STEP 3
Turn the controller’s ON/OFF SWITCH
Turn the plane’s
ON/OFF SWITCH
to “ON”.
ON/OFF
Switch
to “ON”.
NOTE: You are now ready to practice
flying on your INDOOR TRAINER!
Please refer to Page 4 for Basic
Controls.
PRE-FLIGHT CHECK
1. Ensure that the STUNT FLAP is LEVEL
(or ALIGNED WITH) the HORIZONTAL TAIL WING.
CORRECT ALIGNMENT
INCORRECT ALIGNMENT
Horizontal
Tail Wing
Stunt Flap
IF THE FLYING HEIGHT IS TOO LOW OR THE PLANE DOES NOT CLIMB,
THE STUNT FLAP MAY NOT BE HORIZONTAL. ADJUST THE STUNT
FLAP UPWARD UNTIL IT IS LEVEL WITH THE HORIZONTAL TAIL WING.
Adjustments can be made by turning
the STUNT FLAP ADJUSTMENT KNOB.
Stunt Flap
Upwards
• Turning the STUNT FLAP ADJUSTMENT
KNOB counter-clockwise will adjust the
STUNT FLAP upwards.
Stunt Flap
Adjustment
Knob
• Turning the STUNT FLAP ADJUSTMENT
KNOB clockwise will adjust the STUNT
FLAP downwards.
Stunt Flap
Downward
Stunt Flap
Adjustment
Knob
Vertical Tail Wing
2. HORIZONTAL TAIL WING, VERTICAL
TAIL WING and MAIN WING are straight
(not bent or twisted).
Propeller
Propeller
Main Wing
3. Both PROPELLERS can spin freely.
Horizontal
Tail Wing
BASIC FLYING TIPS
• Always launch your plane against the wind direction for best
performance.
• Never fly the plane in high winds. HIGH WINDS WILL LIMIT,
AND MAY PREVENT, YOUR ABILITY TO CONTROL THE
AIRPLANE. USE IN HIGH WINDS MAY ALSO RESULT IN
LOSS OF, OR DAMAGE TO, THE AIRPLANE.
BASIC CONTROLS FOR YOUR AIR HOGSTM SKYWINDERTM
TURN LEFT/RIGHT
NOSE DOWN
Toggle FORWARD
Toggle LEFT or RIGHT
NOSE UP
CLIMB
Press THRUST button
Toggle BACK
LAND – OPTION 1
LAND – OPTION 2
Turn ON/OFF SWITCH to the
“OFF” postion.
NOTE: Once SWITCH is
turned off, you WILL NO
LONGER be able to control
the plane’s direction.
Push LAND button
LEVEL OFF
NOTE: This plane has a
300 foot control range.
Flying out of range may
result in loss and/or
potential damage to the
plane.
Toggle to NEUTRAL position
HOW TO COMPLETE ADVANCED STUNTS ON YOUR AIR HOGSTM SKYWINDERTM
STEP 1
STEP 2
Set controller’s ON/OFF
SWITCH to “ON”.
NOTE: ENGINES WILL
NOW START.
Set plane’s ON/OFF
SWITCH to “ON” for
power.
NOTE: ENGINES WILL
NOT START YET
(See Step 2).
ON/OFF
Switch
STEP 3
STEP 4
Press the THRUST
Launch plane against
wind. Toss it firmly, level
with the ground.
BUTTON to climb.
IMPORTANT: DO NOT
attempt any stunts until
the plane has reached
and leveled off at the
minimum altitude listed
below, and the plane is
flying against the wind.
STEP 5 – STUNTS
1. NORMAL LOOP
MINIMUM ALTITUDE 50 Feet
C. D.
A.
B.
Toggle BACK briefly.
Toggle FORWARD.
As soon as the plane
dives down, pull the
TOGGLE BACK and
HOLD that position to
complete the loop.
After the loop is
completed, return
TOGGLE to NEUTRAL
position to level off.
HOW TO COMPLETE ADVANCED STUNTS ON YOUR AIR HOGSTM SKYWINDERTM continued
STEP 5 – STUNTS continued
2. SIDEWINDER
MINIMUM ALTITUDE 30 Feet
A.
B.
C.
TOGGLE BACK to climb.
TOGGLE back to pull
out of dive then return to
NEUTRAL to level off.
When the plane reaches a vertical
position TOGGLE – LEFT to
complete a LEFT SIDEWINDER. To
complete a RIGHT SIDEWINDER,
TOGGLE – RIGHT when the plane
reaches a vertical position.
REMEMBER:
When you are finished
flying your SKYWINDER™,
turn the plane’s ON/OFF
SWITCH to “OFF” and the
CONTROLLER’S ON/OFF
SWITCH to “OFF”.
ON/OFF
Switch
IMPORTANT INFORMATION – ADULT SUPERVISION IS RECOMMENDED
Keep propellers away from face, eyes, hair, and fingers. Point plane away from face when launching. Do NOT
launch at people or animals. Use caution; make sure people around you know you are playing with Air HogsTM.
Recommended for use in wide-open, grassy areas. Do NOT fly near overhead wires, trees, buildings, or
other obstructions. Do NOT fly in rain, electrical storms, snow, or other adverse weather conditions. Fly on
warm sunny days, with no wind. Do NOT fly in temperatures below 45°F/7°C. Use alkaline batteries only. Use
only the charger and controller included in this package. Please retain this information for future reference.
CHANGING PROPELLERS ON YOUR SKYWINDER™
In case of propeller damage, please use the steps below to replace the damaged propeller:
1. With one hand, grab hold of the PROPELLER.
2. While holding the PROPELLER in place, use your opposite hand to unscrew the removeable
PROPELLER PROPELLER
TIP
PROPELLER TIP with the PROPELLER REPLACEMENT TOOL.
3. After removing the PROPELLER TIP, pull the damaged PROPELLER from the shaft and
replace with a new propeller.
4. While holding the propeller in place, replace the PROPELLER TIP by screwing it back
onto the shaft of the PROPELLER with the PROPELLER REPLACEMENT TOOL.
CAUTION: The damaged propeller may have sharp edges, use caution when handling
the damaged PROPELLER, and dispose of it properly.
TOOL
FRONT VIEW
PROPELLER TIP
PROPELLER TIP
PROPELLER
PROPELLER
TROUBLE-SHOOTING GUIDE
PROBLEM
CAUSE
SOLUTION
Plane will not
loop.
1. Not enough charge.
1. Repeat the charging process. Refer to the “Charging your SkyWinderTM ”
section on Page 2.
2. STUNT FLAP is not
in the correct position.
2. Adjust STUNT FLAP so that it is level with the HORIZONTAL TAIL WING.
3. Winds are too strong.
4. Improper technique.
3. Fly in conditions with little or no wind for best performance.
4 A. LOOPING TAKES TIME AND PRACTICE! Pilots should master
directional control on their TRAINER first. Once pilots are comfortable with
their technique, they should then practice flying outdoors.
B. ENSURE: (1) the minimum altitude is reached before attempting to loop and
(2) the step-by-step toggle directions are followed (See Pages 5 and 6).
5. Rudder Alignment
is OFF.
5 A. If the plane rolls out to the RIGHT before fully completing loops –
Bend the rudder slightly to the LEFT.
B. If the plane rolls out to the LEFT before fully completing loops –
Bend the rudder slightly to the RIGHT.
Plane crashes
OR will NOT fly.
1. Not enough charge.
1. Repeat the charging process. Refer to the “Charging your SkyWinderTM ”
section on Page 2.
2. Plane misaligned
OR damaged from
previous flights.
2. Wings:
• Use clear tape to repair wings.
• Ensure that the HORIZONTAL TAIL WING is parallel to the MAIN WING.
• Ensure that the VERTICAL TAIL WING is 90° with the MAIN WING.
Propellers:
• Ensure that both PROPELLERS can spin freely.
Plane:
• Ensure plane responds to control functions by turning the plane “ON”
while holding it in your hand.
Plane not
1. Interference
from other radio
transmission
1. Turn the plane “ON” and hold it in your hand. If the plane responds
without you touching the controller, there is interference. DO NOT
FLY. You SHOULD NOT fly the plane if it does not respond to your
controller, or if it responds to something other than your controller.
If the problem persists, it is recommended that you fly your plane
in another area.
responding to
controller OR
plane responds
to some other
signal.
signals in the area.
FCC REQUIREMENTS
CAUTION: Changes or modifications to this product not expressly approved by the party responsible for compliance may void the
user’s authority to operate the equipment.
WARRANTY (U.S.A.)
Spin Master Ltd. warrants to the original consumer purchaser, that this product is thoroughly tested and
inspected before shipment and is guaranteed to be free of factory defects in materials and workmanship for
ninety (90) days (unless specified in alternate warranties) from the date of purchase.
In the event of such a defect within the warranty period, Spin Master Ltd., at our sole option, will repair or
replace the product or provide you with another product of equal value. Repair or replacement shipment is
free of charge. Shipping replacement may take 2 to 6 weeks, depending on customer’s location.
In the event of a defect covered under this warranty, please call the toll-free number listed below. Many
problems can be solved in this manner. If necessary, you will be instructed to return the defective part or unit,
packed securely, postage prepaid and insured by the customer, to the address below. Enclose your name,
address, dated sales receipt, and a brief explanation of the defect. There may be an additional handling
charge if you send the entire toy.
The warranty is valid if and only if the product has been operated in accordance with the instructions.
This warranty does not cover worn or defective batteries, damage resulting from neglect, unauthorized
modification, accident, misuse, abuse, any action or omission which constitutes a deviation from the in
structions or from the use of accessories or parts not manufactured by Spin Master Ltd. If the product is
returned without a dated sales receipt the product is excluded from coverage under this warranty.
Spin Master Ltd.’s liability for defects in material and workmanship under this warranty shall be limited
to repair or replacement, at our sole option, and in no event shall we be responsible for accidental,
consequential, or contingent damages (except in those states that do not allow this exclusion or limitation)
or refunds. This warranty is exclusive, and is made in lieu of any express or implied warranty. This warranty
is valid only for products sold in the U.S.A. This warranty gives you specific legal rights and you may
have other rights, which vary from state to state. Some states do not allow the exclusion of incidental or
consequential damages, so the above exclusions or limitations may not apply to you.
Spin Master Ltd. reserves the right to improve the design of any product without assuming any obligation
to modify any product previously manufactured.
If you have a problem, please contact our Customer Care Centre below for help.
Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Spin Master, Inc., PMB #10053, 300 International Drive, Suite 100,
Williamsville, NY 14221
Air Hogs TM and SkyWinder TM are trademarks of Spin Master Ltd.
© 2003 Spin Master Ltd. All rights reserved.
Manufactured for and distributed by Spin Master Ltd.
Conforms to safety standards ASTM F963-03,
EN71 Regulatory Requirements. Products and colors may vary.
Please retain this information for future reference.
MADE IN CHINA.
Spin Master Toys Far East Limited, Rm # 1113, 11/F, Chinachem Golden Plaza,
77 Mody Rd., Tsimshatsui E., Kowloon, HK
Spin Master France SAS, 36 rue de Silly, 92100 Boulogne, France
North American Consumer Information
Phone: 1-800-622-8339
TM
REV 6 US ENG Asst. #44000.
|