2-593-588-11(1)
Installing the satellite speakers
(See fig. A)
The satellite speaker can be used either placed on a desk
or attached to a wall.
Using the headphones/
earphones
Connect the headphones/earphones to the PHONES
jack on the controller.
C
PC, CD or MD
Walkman, etc.
Note
When you use the satellite speaker on a desk
(See fig. A-A)
By attaching the stand to the satellite speaker, it can be
placed on a desk.
Turn off the MEGA BASS or BASS BOOST (Walkman,
etc.) function as it may cause audible distortion.
Active Speaker System
POWER
ON
OFF
VOLUME
MIN
MAX
MAX
BASS
MIN
PHONES
Troubleshooting
Should you encounter a problem with your speaker
system, check the following list and take the indicated
measures. If the problem persists, consult your nearest
Sony dealer.
1
2
Slide the stand into the slot at the
Operating Instructions
Mode d’emploi
Manual de instrucciones
bottom of the satellite speaker.
The stand allows you to adjust the satellite
speaker to the desired angle.
Ensure the stands are locked.
Push the stand into the slot until a “click” sound is
heard.
There is no sound from the speaker system.
• Make sure all the connections have been correctly
made.
• Make sure the VOLUME dial and the each speaker’s
volume dial on the controller have been turned up
properly.
SRS-D211
Note
Do not put your finger into the slot of the satellite
speaker when you lock the stand. It may cause an
injury to your finger.
Subwoofer
Controller
• Make sure the connected component has been turned
up properly.
Front speaker (Left)
2005 Sony Corporation
Printed in Malaysia
• Check if the headphones are connected. If they are,
disconnect them.
Front speaker (Right)
The sound is distorted.
• Turn down the volume level on the connected
component. Or, if the connected component has a
BASS BOOST function, set it to off.
• Rotate BASS on this unit to reduce the bass volume.
• Turn VOLUME on this unit down to reduce the
volume.
Printed on 100 % recycled paper using VOC
(Volatile Organic Compound)-free vegetable oil based ink.
D
POWER
ON
There is hum or noise in the speaker output.
• Make sure all the connections have been correctly
made.
• Make sure none of the audio components are
positioned too close to the TV set.
POWER
Package Contents
OFF
When you use the satellite speaker attached
to a wall (See fig. A-B)
The satellite speaker can be attached to a wall. Follow
the Notes (below) to install safely. Improper installation
may result in the speaker falling and causing bodily
injury or damage to the speaker or other object.
VOLUME
MIN
MIN
MAX
MAX
VOLUME
PHONES
BASS
The sound has suddenly stopped.
Make sure all the connections have been correctly
made.
PHONES
1
Secure the hollow wall anchor in the wall
— refer to the illustration.
The brightness of the POWER indicator is
unstable.
The brightness of the POWER indicator may become
unstable when the volume is turned up. This is not a
malfunction.
Notes
• Confirm wall thickness is sufficient. A
minimum thickness of 9.5 mm is recommended
for plasterboard.
Controller
Subwoofer with wired controller (1)
• Use the specified clamp (hollow wall anchor,
not supplied) when attaching to plasterboard.
• Refer to the supplied operating instructions
using a hollow wall anchor.
VOLUME: Controls total volume level.
BASS: Adjusts bass level (Subwoofer).
Specifications
PHONES: Connect the headphones for personal listening.
Speaker section
Satellite speaker
Speaker system
Speaker units
Enclosure type
Impedance
• Use wall anchors of at least 20 kg hanging
capacity.
• Refer to the instruction supplied with hollow
wall anchor.
• Requires ø 4 mm hollow wall anchor.
• Set up the head of a hollow wall anchor 5 mm
from the wall.
• Apply a bond (anaerobic threadlocking
material) to the hollow wall anchor to prevent
the screw loosening.
Full range, magnetically shielded
Satellite speaker (2)
Stand (2)
5.7 cm, cone type
Closed type
4 Ω
On operation
• Do not drive the speaker system with a continuous
wattage exceeding the maximum input power of the
system.
• Before connecting, turn off the speaker system, the
PC and audio component to avoid damaging the
speaker system.
English
Cord length
2 m
A
Before operating the unit, please read this manual
thoroughly and retain it for future reference.
Subwoofer
Speaker system
Speaker units
Enclosure type
Impedance
Woofer
12 cm, cone type
Bass reflex
8 Ω
• The volume level should not be turned up to the
point of distortion.
• Although this system is magnetically shielded, do not
leave recorded tapes, watches, personal credit cards
or floppy disks using magnetic coding in front of the
system for an extended period of time.
A
WARNING
To prevent fire or shock hazard, do not expose the
unit to rain or moisture.
2
Attach the satellite speaker to the wall.
Insert the wall anchor in the anchor hole of the
satellite speaker.
Amplifier section
Rated output
5 W (10% T.H.D., 1 kHz, 4 Ω)
(Satellite speaker)
To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
To prevent fire, do not cover the ventilation of the
apparatus with news papers, table-cloths, curtains, etc.
Do not place lighted candles on the apparatus.
To prevent fire or shock hazard, do not place objects
filled with liquids, such as vases, on the apparatus.
,
25 W (10% T.H.D., 100 Hz, 8 Ω)
Notes
(Subwoofer)
Connecting cord with stereo mini
plug (2m) × 1
Stereo mini jack × 1 (INPUT 2)
4.7 kΩ (at 1 kHz)
Stereo mini jack × 1 (PHONES)
• Detach the stand from the satellite speaker
before attaching to the wall.
Input
If the TV picture or monitor display is
magnetically distorted
Reverse the stand to
change the speaker
angle.
• Ensure that the satellite speaker is securely
attached to the wall before use.
Input impedance
Output
Although this system is magnetically shielded, there may
be cases that the picture on some TV sets/personal
computers may become magnetically distorted. In such a
case, turn off the power of the TV set/personal computer
once, and after 15 to 30 minutes turn it on again. In the
case of a personal computer, take appropriate measures,
such as data storage, before turning it off.
Satellite speaker
Stand
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
General
This warranty is valid only in the United States.
Dimensions (w/h/d) Approx. 50 × 140 × 99 mm
Hooking up the system
(See fig. B)
(2 × 5 5
Approx. 98 × 124 × 84 mm
(3 7 × 5 × 3 3
in.) (Satellite speaker,
on a desk)
Approx. 98 × 98 × 83 mm
(3 7
in.) (Satellite
/
8
× 4 in.) (Controller)
Anchor hole
CAUTION
You are cautioned that any changes or modification not
expressly approved in this manual could void your
authority to operate this equipment.
/
8
/
8
B
When there seems to be no improvement, locate the
system farther away from the TV set/personal
computer. Furthermore, be sure not to place objects in
which magnets are attached or used near the TV set/
personal computer, such as audio racks, TV stands, toys
etc. These may cause magnetic distortion to the picture
due to their interaction with the system.
Hollow wall anchor
(ø 4 mm, not supplied)
1
2
Connect the satellite speakers to the
/
8
× 3 7
/
8
× 3 3
/
8
subwoofer.
Confirm the location of the satellite speakers, and
then connect to their respective jacks.
speaker, attached to a wall)
NOTICE FOR THE CUSTOMERS IN THE USA
Approx. 163 × 267 × 301 mm
(6 1
/
2
× 10 5
/
8
× 11 7
/8
in.) (Subwoofer)
Mass
Approx. 134 g (5 oz.) (Controller)
Approx. 294 g (10 oz.)
(Satellite speaker)
Connect the controller to the source
equipment.
– PC, etc.:
Connect the controller and the LINE OUT or
headphones jack of a PC, etc. with the connecting
cord (connected with the controller). For details,
refer to the operating instructions of the PC.
Approx. 4.2 kg (9 lb. 4 oz.)
(Subwoofer)
2 m (Controller to subwoofer)
2 m (Power cord)
On placement
,
• Do not set the speakers in an inclined position.
• Do not leave the system in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust, moisture, rain or mechanical shock.
• Do not install the satellite speaker anywhere other
than on a wall.
Cord length
Power consumptions
18 W
Optional accessories
– CD/MD Walkman, etc.:
5 mm
Connecting cord RK-G136, RK-G138
Plug adaptor PC-236MS
This symbol is intended to alert the user to
the presence of uninsulated “dangerous
voltage” within the product’s enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
Connect the INPUT 2 jack of the controller and the
LINE OUT or headphones jack of a CD/MD
Walkman, etc. The connecting cord is not supplied
with this system.
• Do not hang anything on the satellite speaker.
Note
Note
Do not hang anything on the
satellite speaker.
First, be sure to apply a bond
(anaerobic threadlocking material)
to the hollow wall anchor to
prevent the screw loosening.
ø 7 mm
Design and specifications are subject to change without
notice.
On cleaning
Do not use alcohol, benzene, or thinner to clean the
cabinet.
Note
ø 4 mm
Turn on either of the connected equipment to
listen to its sound.
This symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
If you have any questions or problems concerning your
speaker system, please consult your nearest Sony
dealer.
3
4
Connect the subwoofer to the wall
outlet.
9.5 mm or more
Position the speakers. (See fig. C)
Precautions
On safety
The nameplate indicating operating voltage, power
consumption, etc., is located on the rear exterior.
• Before operating the system, be sure that the
operating voltage of the system is identical with that
of your local power supply.
Listening to the sound (See fig. D)
B
First, turn down the volume on the controller. The
volume should be set to minimum before you begin
playing the programme source.
Satellite speaker
(rear)
to LINE OUT or
Where purchased
U.S.A./Canada
Operating voltage
120 V AC, 60 Hz
headphones jack
(stereo mini-jack)
1
Set the POWER switch to ON on the
controller.
The POWER indicator lights up.
European countries 220 – 230 V AC, 50 Hz
Other countries
• 120 V AC, 60 Hz
• 220 – 230 V AC, 50 Hz
CD/MD Walkman*, etc.
2
Turn on the desired equipment
connected to the controller.
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
• Unplug the system from the wall outlet if it is not to
be used for an extended period of time. To disconnect
the cord, pull the cord by grasping the plug. Never
pull the cord itself.
• Should any liquid or solid object fall into the system,
unplug the system’s power cord and have the system
checked by qualified personnel before operating it
any further.
• The AC power cord should be changed only at a
qualified service shop.
• For efficient heat dissipation, ensure there is sufficient
space to the rear of the subwoofer. Also, avoid
placing objects on the unit.
to INPUT 2
jack
to FRONT L jack
to FRONT R jack
Connecting cord
(not supplied)
Note
Do not turn on both connected equipments as it
may cause double sound.
Connecting cord
(connected with controller)
3
Adjust the VOLUME control on the
Controller (rear)
controller.
You can adjust the volume of the subwoofer and
each satellite speaker.
Subwoofer (rear)
When connecting to the headphone output, also
adjust the volume of the connected component.
After listening, set the POWER switch to OFF.
The POWER indicator goes off.
to LINE OUT or
headphones jack
PC, etc.
• Do not insert your hand or any objects into the hole
of the subwoofer.
to wall outlet
*
“WALKMAN” is a registered
trademark of Sony Corporation to
represent Headphone Stereo products.
|