To display specified material: Select “Specified
Contents” from “Recovery Mode”. When “Specified
Contents” is selected, enter the index number of the
materials in the “Index” box.
Make settings for serial communication to control
external devices such as PDP.
Use for scheduled playback: Select whether or not
the
(SERIAL) connector located on the rear
panel of the unit is used. Select “yes” to control
external devices using the firmware normally installed
in the unit at the factory. Usually use the unit with
“yes” selected. Select “no” to interface between the
unit and external devices using the RS-232C
application software installed in the unit created by a
third party.
Communication speed: Select the communication
speed from the “Speed (bps)” drop down list box.
Parity: Select the communication parity from “Parity”
drop down list box.
2
Make settings for the play log.
You can select whether or not play logs sent from this
unit are saved.
To save play logs: Select “On” from “Play log
Setting”.
To discard play logs: Select “Off” from “Play log
Setting.”
To specify the number of play logs to be
saved
Enter the number of play logs to be saved in the “The
Number of log records” box. You can specify up to
20,000.
Time out: Set the time out for response from devices.
Maximum length is 15 seconds.
7
8
Select the font and font size (pixels) to be used on the
Web screen which is played by the unit.
3
Set the start time for the hard disk sleep.
To maintain the functions of the hard disk of this unit,
this unit allows the hard disk to sleep for about five
minutes once a day.
Set the start time of this sleep period (hour/minute) in
the “Break time from” boxes.
Click the “Send” button.
The settings carried out on this page are sent to the
NSP-1.
To resume the setup process, go to another page
without carrying out step 8.
Note
9
Click the “Reboot” button.
For safe operation of the system, this unit carries out a
maintenance process, turns off once and then on again
automatically once a day. Thus, it cannot play
materials nor receive files during these minutes of
sleeping. It is recommended that you set the time for a
time of day when the schedule is affected as little as
possible. 00:00 a.m. is the default time. Change the
time as required.
This unit is turned off and then on again. The settings
made are now valid.
Making Account Settings
To access the Web page of the NSP-1, it is necessary to
enter a user name and password. The Account Settings
page allows you to change the passwords.
Users cannot access this page without proper
authorization.
4
5
Make settings for the screen saver.
To use the screen saver function: Select “On” from
“Screen Saver”.
To not use the screen saver function: Select “Off”
from “Screen Saver”.
Note
Be sure to change the passwords.
The number of characters that can be entered to make up a
password is between 6 and 14 characters.
You can use alphabetical and numeric characters
excluding *, [, ], \, %, /, $, “, &, and ‘.
Make settings for automatic deletion of materials.
By setting a time for automatic deletion when
materials are registered, materials are automatically
deleted at the specified period.
Setting/changing the password for the
administrator
This is the password for a user who is authorized to make
system settings for this unit.
To activate the automatic delete function: Select
“On” from “Auto Delete”.
To not activate the delete function: Select “Off”
from “Auto Delete”.
6
Make settings for serial communication on the “Serial
Communication” column.
1
Enter the new password in the “Password” text box of
the “Admin Account” column.
12
Setup
