Assembly Guide
CW-119
CW-119 Assembly Guide
Obtaining Service
Important Safety Instructions
For information about product operation or service,
you can also find customer support numbers or a list of
Precor authorized service centers.
When using exercise equipment, basic precautions
should always be taken, including the following:
•
•
Read all instructions before assembling the
CW-119. These instructions are written for your
safety and to protect the unit.
If you contact Customer Support, have the serial
number available.
Read each step in the assembly instructions and
follow the steps in sequence. Do not skip ahead. If
you skip ahead, you may learn later that you have
to disassemble components and that you may
have damaged the equipment, which would void
the Precor Limited Warranty.
You can find the serial number printed on a label
affixed to the CW-119. For future reference, write the
serial number in the space provided below.
Serial number: _______________________
•
•
•
Assemble and operate the CW-119 on a solid, level
surface. Locate the unit a few feet from walls or
furniture to provide easy access.
Do not allow children or those unfamiliar with its
operation on or near the equipment. Do not leave
children unsupervised around the unit.
Use the equipment only for its intended purpose.
Do not use accessory attachments that are not
recommended by the manufacturer, as such
attachments may cause injuries.
•
Do not attempt to service the CW-119 yourself. The
unit does not contain any user-serviceable parts.
Important Safety Instructions
page 3
CW-119 Assembly Guide
Table of Contents
Important Safety Instructions .................................................................................. 3
Obtaining Service .....................................................................................................................................
3
Preparations............................................................................................................... 5
Unpacking the Equipment.........................................................................................................................
Required Tools ..........................................................................................................................................
Installation Requirements .........................................................................................................................
Hardware Kit .............................................................................................................................................
5
5
5
6
1
2
Assembly Instructions .............................................................................................. 7
Open the Box ............................................................................................................................................
Assemble the Unit.....................................................................................................................................
Assemble the Pads ...................................................................................................................................
7
8
9
Clean the Pads and Assembly .................................................................................................................. 10
Limited Warranty Statement...................................................................................................................... 11
Specifications............................................................................................................................... Back cover
Table of Contents
page 4
CW-119 Assembly Guide
Required Tools
Tools that you need to obtain before assembling the
unit include:
❏
❏
Wire cutter or utility knife
SAE hex key set
1
Preparations
Installation Requirements
Follow these installation requirements when
assembling the unit:
The CW-119 parts are inspected before shipment.
Each unit contains several pieces that require
assembly.You must obtain adult assistance during the
assembly process.
•
•
Review the Important Safety Instructions.
Assemble the unit where it will be used.
Provide ample space around the unit.
Unpacking the Equipment
When you open the box, carefully unpack the pieces
and lay them on the floor near the location where you
plan to use them.
•
•
Install components in the sequence shown.
Insert all fasteners in the same direction.
For aesthetic purposes, insert all the fasteners
in the same direction unless instructed (in text or
illustrations) to do otherwise.
CAUTION: Be careful when you remove the
packaging material with a utility knife. Do not cut
the upholstery or scratch the paint.
•
Leave room for adjustments. Tighten the
fasteners to keep the unit stable, but leave room for
adjustments. Do not fully tighten fasteners until
instructed to do so.
If any items are missing, contact the dealer from whom
you purchased the unit. For more information, refer to
Obtaining Service.
Preparations
page 5
CW-119 Assembly Guide
Hardware Kit
Fastener
Qty
³⁄₈-inch x ¾-inch buttonhead screw (A)
4
³⁄₈-inch split washer (B)
4
⁵⁄₁₆-inch x 1¼-inch buttonhead screw (C)
7
7
⁵⁄₁₆-inch split washer (D)
⁵⁄₁₆-inch washer (E)
7
Preparations, continued
page 6
CW-119 Assembly Guide
Assembly
Instructions
2
Assembly of the CW-119 takes about 45 minutes to
complete. If this is the first time you have assembled
this type of equipment, plan on allowing more time.
Be careful to open boxes and assemble components
in the sequence presented in this manual.
Note: With so many assembled parts, proper alignment
and adjustment is critical. While tightening the fasteners,
be sure to leave room for adjustments. Do not fully
tighten fasteners until instructed to do so.
Back Pad
Seat Pad
Open the Box
Use wire cutters to open the box and remove the
packing materials.
The illustration shows how the CW-119 will look when
you have completed its assembly. The callouts identify
specific pieces.
Main Frame
Stabilizer
Assembly Instructions
page 7
CW-119 Assembly Guide
Assemble the Unit
Attach the Main Frame to the Stabilizer using
four ³⁄₈-inch X ¾-inch buttonhead screws (A)
four ³⁄₈-inch split washers (B)
Wrench tighten.
Note: Make sure the wheels on the Stabilizer are
positioned as shown in the illustration.
4 - ¾" buttonhead screws
4 - split washers
Assemble the Unit
page 8
CW-119 Assembly Guide
Assemble the Pads
1. Attach the Seat Pad to the Seat Adjustment using
three 1¼-inch buttonhead screws (C)
three ⁵⁄₁₆-inch split washers (D)
three ⁵⁄₁₆-inch washers (E)
Wrench tighten.
2. Attach the Back Pad to the Back Adjustment using
four 1¼-inch buttonhead screws (C)
four ⁵⁄₁₆-inch split washers (D)
four ⁵⁄₁₆-inch washers (E)
Wrench tighten.
This completes the assembly of the CW-119.
3 - 1¼" buttonhead screws
3 - split washers
3 - washers
4 - 1¼" buttonhead screws
4 - split washers
4 - washers
Assemble the Pads
page 9
CW-119 Assembly Guide
Clean the Pads and Assembly
To clean the pads, moisten a clean, soft cloth in a mild
solution of soap and water and wipe all the parts
thoroughly. Dry the pad with a clean, dry cloth.
Use the same procedure to clean the Main Frame and
plastic parts.
Frequently vacuum the floor underneath the CW-119 to
prevent the accumulation of dust and dirt. If necessary,
use the Seat Pad to lift the front end and tip the
CW-119 onto its wheels to roll it to a different location.
Clean the Pads and Assembly
page 10
Limited Warranty
Precor, Incorporated (PRECOR) will repair or replace any of the following components which
are defective as to materials or workmanship for products manufactured and sold after June 1,
1990:
An individual purchasing PRECOR equipment in California for personal, family or household
purposes has the right to have defective equipment serviced or repaired during the warranty
period. The warranty period will be extended for the number of whole days that the equipment
is out of the buyer’s hands for warranty repairs. If a defect exists within the warranty period, the
warranty will not expire until the defect has been fixed. The warranty period will also be
extended if the warranty repairs have not been performed due to delays caused by
circumstances beyond the control of the buyer, or if the warranty repairs did not remedy the
defect and the buyer notifies PRECOR or its authorized dealer or sales representative of the
failure of the repairs within sixty (60) days after they were completed. If after a reasonable
number of attempts, the defect has not been fixed, the buyer may return the equipment for a
replacement or a refund subject, in either case, to deduction of a reasonable charge for usage.
This time extension does not affect the protections or remedies the buyer has under other laws.
Purchasers of PRECOR strength equipment have the right to bring an action at law or in equity
to resolve disputes concerning or to enforce the provisions of this warranty. Some states do not
allow the exclusion of limitations of incidental or consequential damages and/or limitation on
how long an implied warranty lasts, so the above limitations or exclusions may not apply to all
Customers. This warranty gives Customers specific legal rights; Customers may also have other
rights which may vary from state to state.
ICARIAN & STRETCH CENTER:
Lifetime:Structural Steel Framework
FiveYears:
Rotary Bearings, Weight Stacks, Pulleys, Guide Rods, Structural Moving
Parts
OneYear:
Ninety Days:
Cable, Linear Bearings, Springs
Upholstery, Handgrips, All Other Items Not Listed
Not withstanding the above, all warranties provided by PRECOR shall terminate upon transfer
of ownership of the equipment by the original owner. PRECOR may require the Customer to
affirm that he is the original owner of the equipment before providing warranty services. This
warranty does not extend to any components which become defective due to abuse, misuse, or
lack of proper maintenance or if the equipment under warranty has been modified or altered in
anyway. The Customer seeking repair or replacement of defective equipment must notify
PRECOR at the address set forth on the back cover of such defect, admit PRECOR authorized
service representatives during normal business hours to effect repairs and pre-pay all defective
equipment within thirty (30) days of its receipt of notice of the defect from a Customer or the
equipment itself.
THIS WARRANTY IS LIMITED TO REPAIR AND/OR REPLACEMENT OF DEFECTIVE
EQUIPMENT. Except to the extent it is precluded from doing so in a particular state or other
jurisdiction by applicable law. PRECOR DISCLAIMS ANY AND ALL OTHER WARRANTIES
WHETHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED
WARRANTY OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Moreover, if any damage or defect is caused by the transport carrier, such claims must be filed
with the carrier at the time of delivery. PRECOR DISCLAIMS ANY AND ALL RESPONSIBILITY
FOR SUCH DAMAGE OR DEFECT, NO DEALER, EMPLOYEE, SALES REPRESENTATIVE
OR AGENT HAS ANY AUTHORITY TO MAKE ANY WARRANTIES OR REPRESENTATIONS
CONCERNING PRECOR EQUIPMENT BEYOND THOSE SET FORTH IN THIS WARRANTY
AND IN OTHER OFFICIAL PRECOR LITERATURE: AND PRECOR DISCLAIMS ALL
RESPONSIBILITY FOR ANY SUCH UNAUTHORIZED WARRANTIES OR
REPRESENTATIONS.
Effective 27 November 2006
P/N CW31973-102
page 11
CW-119 Assembly Guide
Notes:
page 12
CW-119 Specifications
Length: 48 inches (122 cm)
Height: 39 inches (99 cm)
Width: 30 inches (76 cm)
Shipping weight: 84 lb (38 kg)
Precor Incorporated
20031 142nd Avenue NE
P.O. Box 7202
Woodinville, WA USA 98072-4002
1-800-347-4404
Precor, Icarian, and Move Beyond are registered trademarks of Precor Incorporated.
Copyright 2008 Precor Incorporated.
Specifications subject to change without notice.
NOTICE:
Precor is widely recognized for its innovative, award winning designs of exercise equipment. Precor aggressively seeks U.S. and
foreign patents for both the mechanical construction and the visual aspects of its product design.Any party contemplating the use of
Precor’s product designs is hereby forewarned that Precor considers the unauthorized appropriation of its proprietary rights to be a
very serious matter. Precor will vigorously pursue all unauthorized appropriation of its proprietary rights.
CW-119 Assembly Guide CW33677-102
Limited Warranty Statement CW31973-102
16 September 2008
|